Ridgid 29993 227S Stainless Steel Pipe Reamer Tool, 1/2-inch to 2-inch Inner/Outer Reamer, Chrome, Small

Model 227 here is the big brother to model 223, which works with up to 1" sch 40 and SDR21 PVC, see my review there for that one. This larger model 227 works just perfectly on 1-1/4" schedule 40 PVC. See my photos here. I don't have a piece of 1-1/2" PVC on hand to try, but this tool should work just fine with that size PVC pipe too, since it is 1-1/2" ID (inner) and 1.90" OD (outer), within the 2-inch spec of the tool. I show a photo of the 223 (small) and 227 (big) side by side! Ha you can see the 227 is a substantial tool, which it needs to be for these larger PVC pipes. From the photos you can see that 1-1/4" PVC pipe is the size of the entire smaller model 223 tool (which won't work), while it just fits right into this bigger model 227. I have before and after photos shown of a chamfer I just did (on the outside edge) and ream (on the inside edge). Especially take a look at that last photo which is done with 10x magnification. The chamfer & ream shows up well. Compare the before and after photos. Clearly the chamfered edge is the one you would want to insert into your PVC fitting, after applying PVC glue to both, to keep from scraping the glue off inside the fitting! FWIW, the small loss of pipe wall thickness due to the small chamfer and ream area doesn't matter a bit for pressurization, since the side of the PVC pipe behind it is what gets bonded inside the PVC fitting. I didn't show it, but a PC canned air keyboard duster blows those PVC shavings right out of both ends of the tool. Not much else to say here other than hit that "add to cart" button to add a quality tool to your collection!

I bought it cause,I can actually use it on 1/4 stainless steel tubing.

Works great!!! Saves time on jobs.

I am a novice who so happened to need this tool to replace old piping in order to install a new sump pump. I chose this one because of the many accolades of support in many reviews. This tool performs as advertised. The cuttings are clean, beautifully beveled/honed, and is designed to last a lifetime. One of the best tools I've purchased.

Second one a must have for press fittings. Work great on solder fittings also as most sweat fittings today have ZERO quality control.

this thing is solid and works well. it works best when you can put the pipe in a chain vise. its hard on your wrists twisting it back and forth while applying pressure to shave the metal. other than that it works great

Nice works great

This is a beefy reamer. Blades are sharp and cut cleanly. Only downside is it doesn’t fit on 2” PVC or ABS