AUTOUTLET 2Pcs P6100 100MHz Universal Oscilloscope Probe,10:1 and 1:1 Switchable Oscilloscope Clip Probes with BNC to Minigrabber Test Lead Kit

Good quality. Worked as it should.

Pretty nice leads Price was right

They are cheap scopes but they are accurate enough and attenuate perfectly. Would recommend.

My only complaint is that I wish their cables were longer, but they seem decent other than that.

I used these to replace my 40-year-old Tektronix probes. They look and operate very similarly. See the attached picture for comparison. The tips work well, grab and make good contact. There is an x1 and x10 switch to attenuate the signal. They are solid and rugged enough to get a lot of use from them.

I have an older Tektronix oscilloscope which needed new probes as the older ones were creating noise and I did not want to spend over a $100 bucks for a new Tektronics set so I deceded on this set. I have not had these probes very long but so far I am pleased with this set, as it turned out it is a great bargin at this price and it is a 1X/10X probe. Great flexibilty, strong clips for grabing the componet leads firmly and strong bond between the connectors and wire.

The tips on the prob are made of wider metal loop than most. They don’t have a lot of clamping pressure and do not grab small wires tightly enough to make a good connection. They do work adequately, but are not exceptional.

Nice stuff for the price. The oscilloscope leads do have a trimmer to adjust the capacitance when calibrating the test lead to your scope.

After no tracking information, this item appeared out of thin air! After inspecting it, it appears to be a quality item of good value for the asking price. Nice job, looking fwd to a long use. Impressed with packaging also, Good Job Hancock !

プローブの周波数補正用トリマーが収められている部分がシールドされていないので、この部分はノイズを受けやすい。ただし、よほど環境が悪くなければ問題なく使えます。 他社製の物ではプローブ先端の手に持つところあたりがノイズに弱かったので、安価なプローブは特性を理解して使えばよいと思います。

Wasn't expecting much at this price point, but was better than expected. Could only adjust compensation on one probe to the correct setting. The second one I could only get about 97% compensation.

I had a bit of an issue with one of the probes and the seller replaced that for me with ease. The probe works amazingly well and is made from decent material so I am happy :)

Wanted new probes for my overhauled Tek. Happy with them. Compensation works fine but dont forget to check the range for your scope. Cheap enough to carry a spare if they break. It seems all these Chinese probes are actually all made by the same factory - just the branding changes.