Beck/Arnley Throttle Body Gkt - 039-5062

Fits perfectly especially due to supplier being the oem, easy installation and very fast shipping. Will buy from this seller again.

muy bién Gracia

Purchased this replacement gasket as I was set to do a CCV replacement on a BMW 330ci. The gasket was most likely aftermarket but none the less, it looked and fit just like OEM material. After the entire car was put back together there were no error codes or obvious issues present, so it is safe to assume the gasket does in fact do it job, and well.

Good price and quality.

fit the throttle body perfectly

THIS WAS EVIDENTLY A UNIVERSAL KIT MADE TO FIT SEVERAL MODELS AND YEARS. QUALITY WAS ACCEPTABLE. HOSES AND CONNECTORS SEEMED A LITTLE LESS ROBUST AS THE ORIGINALS. PCV/OILSEPARATOR SEEMED EQUAL IN CONSTRUCTION TO ORIGINAL. EVERYTHING FIT ALTHOUGH A COUPLE OF THE HOSES DIDN,T SEEM TO HAVE THE PROPER ANGLE ON THE CONNECTORS, BUT WITH A LITTLE PATIENCE IT ALL WENT TOGETHER AND FUNCTIONS PROPERLY. THE KIT SHOULD HAVE ALSO INCLUDED A COUPLE OF FEET OF 1/4 INCH VACUUM HOSE BUT THAT WAS JUST A QUICK TRIP TO THE PARTS STORE. IT WAS A ABOUT A 4 TO 5 HOUR JOB IF NO BREAKS WERE TAKEN. THE MOST DIFFICULT TASK WAS THE HOSE THAT SNAKED THROUGH THE INTAKE TO THE PVC. TAKE A REAL GOOD LOOK AT THE CONNECTION AND TRY TO FIGURE OUT THE BEST WAY TO DO IT. WORKING IT THROUGH THE INTAKE MANIFOLD AND ATTACHING TO THE PVC BEFORE SCREWING THE PVC DOWN SEEMED TO OFFER A LITTLE MORE WIGGLE ROOM TO GET IT HOOKED UP. NEXT TIME WILL BE EASIER, GOOD LUCK!!!

Good quality. Fit my 2000 328ci perfect

Vehicle: 2002 BMW X5 3.0i M54B30 AWD A/T It works perfectly and feels substantial. BMW motors run so hot it is standard practice to replace rubbers under the hood. Quite satisfied with this replacement part.

A bit snug to get in the slot but had now worry about it falling out during install. Looked exactly like factory and car runs great - throttle body to intake so pretty critical to get a good seal.

igual que original o mejor, quedo perfecto en el cuerpo de aceleración, sin problemas y fácil de instalar.

Prefect fit

The quality of the gasket is good and one that you should consider replacing when you work on you replace your pcv valve.

DO NOT ORDER THIS O RING if you need the throttle body gasket for a BMW 3.0 DISA valve. It is too large, and entirely the wrong shape. If you have an original BMW valve, the reddish sealing ring is glued or melted in place, and not serviced separately by BMW. It will have to be prised out with sharp pointed tools and removed in its entirety. Fortunately, it is serviced by the aftermarket, but only as part of a kit with other parts that might not be needed. Judging by its size, it is more likely a replacement for the BMW pcv valve.