JR Products 305.1203 12015 White Double SPST On-Off Switch with Bezel

Actually like this switch better than the original. Instead of a hard click this one is a smooth transition from on to off with a larger button.I will buy this style from now on if I need another replacement

I installed this to replace a double set of the tiny rocker switches in my travel trailer. I saw these in the newer RVs at an RV show and cheaper to upgrade my switches and LED fixtures than to buy a new trailer. I did have to spend some time with a dremel and rough grit sanding drum to nearly double the size of the hole behind the original switch. But once installed these toggle much smoother and easier than the small original switches. I've ordered the single gang unit to install in my bathroom for the same reason.Only negative I can see is the switch positions are not marked for ON and OFF like my original switches. Otherwise, I love these and hope they hold up

I love the big buttons very easy to push

These switches are designed to be used with .187" wide push-on connectors. Many RVs (mine included) use the more standard .250" push on connectors. The .250" connectors will work on this switch if the .250" connectors are crimped down slightly so they slide on the switch pads tightly. If it isn't clear what I mean right now, it will be obvious what needs to be crimped (tightened) when the connectors are put on the switch. If the connectors slide on loosely, it will be clear what needs to be done. Just don't over do the crimping or the terminals will not slide on at all. Small needle nose pliers work best for this task. Clearance in the back might be a problem if the walls are extremely thin. Mine are thin, but there was enough room for the switch on an exterior wall next to the door.Otherwise, the switch works just fine. This switch requires a slightly larger cutout hole than the original double switch. But this is an RV - I could enlarge the cutout with a butter knife!

I installed this switch in the bathroom of my travel trailer so the could control the vent fan from the wall instead of a roof switch that the manufacturer’s, now all family members can reach to turn on fan and it looks great too.

My yard needed light, and my shed needed lighting/power. So I used these parts below to make a solar powered shed. My 2 yard lights run dusk to dawn (car battery handles that 20 watt load without stressing it) and light up WELL an area 20' out from shed, with enough light to see a person/animal another 30' at least. Been going for a month now with no issues even with my girls sleeping in the shed multiple nights using interior lights and power inverter. I'm gonna copy this for my 12' enclosed trailer next.X1 - Any car battery works, for heavy use (and very long life) highly recommend  Optima Batteries 8052-161 D31M BlueTop Starting and Deep Cycle Battery X1 -  20W 12V Solar System Kit : 20 Watt Polycrystalline Solar Panel&Battery Clips&3A Charge Controller X2, 1ea black 1ea red -  Grand General 55235 White 100' 16-Gauge Primary Wire X1 -  JR Products 12015 White Double SPST On-Off Switch with Bezel X1 -  HIGHROCK Ac Dc 12v 10a Auto on Off Photocell Light Switch Photoswitch Light Sensor Switch X2 -  AUDEW 40 LED White Interior Light Kit For LWB Van Lorries Sprinter Ducato Transit VW X1, for high draw 110v inverter -  Grand General 55251 Red 12-Gauge Primary Wire X2 -  GLW® 10w 12v Ac or Dc Warm White Led Flood Light Waterproof Outdoor Lights 750lm 80w Halogen Bulb Equivalent Black Case

Used in camping trailer, needed to add a small fan. Matched the switches in the trailer

The contruction quality is on par with other switches in my RV. The rocking action has a nice feel and a positive click when switching on and off. The spade terminals appear a little narrow, but once connected, the female connector is very difficult to remove. I would recommend not making any connections until you’re sure they wont have to come back off to prevent damaging the terminals like some other reviewers have done. My only negative is that no mounting screws were included.

These were very inexpensive and easy to instal. They are working very well for us.

MUY BUENA CALIDAD

This a good set of switches for an rv build or a replacement. I used them in a enclosed trailer build and it worked great.

Fit, finish and operation is great.A bit pricey thou in my opinion

These work exactly as well as those ugly "offroad" toggle switches but adds a bit of tidiness to a campervan build.Switches are confident, and seem to be built well. Installation is simple and doesn't feel cheap.Very happy, will be buying these if I need any additional switches necessary for my 12v applications.