【2026 Upgraded】 279838 W10724237 Dryer Heating Element kit fit for Whirlpool Maytag Kenmore Amana Roper Dryer Thermostat Thermal Fuse 3403585 Ned4655ew1 Wed4815ew1 Medc215ew1-AMI PARTS

My dryer was blowing the breaker when I tried to start a cycle. This was because the heating element coil had stretched and touched the dryer frame, causing a short. It also blew/tripped the white rectangular non-resetable fuse. I like this kit because it comes with the heating element and every thermal fuse (with some backups) you might need to get your dryer working again. I replaced the heating element and the white fuse and the dryer is working like a charm. REMEMBER, if your fuses are blowing, it means the dryer is Over-Temping and it's most likely happening because your dryer vent tube and/or outside vent is blocked with lint, which reduces air flow and thus raises the operating temperatures (drying is probably much slower than it used to be too). Run your dryer on the no-heat setting and go outside and see if you are getting good air flow - it should be like a big wind, not a small breeze.

Perfect fit and easy to install.

This kit worked great and was very easy to install. Since the kit came with all the key components I replaced everything even though it was my element that shorted out. Now dryer drys clothes in one cycle!

I bought this to replace the original 15yr old element that failed. Was just going for the quick cheap dryer fix as this is staying with the house when we sell soon. Loved the price, saw "upgraded" and it came with a bunch of the sensors, fuses and such. Worked for about 3 months on MED heat setting then did the same thing my old element took 15yrs to do... This is actually worse than my old one as the ceramic isolators that hold the wires apart clearly cracked. 2 of the springs fused to each other and one snapped apart. Lots of black charring. Yikes! It's a quick and easy job to replace but I don't want to do it 2-3 more times before we're out of this house or burn the place down. The OEM is about 2x the cost but time is money and I don't feel like having to do this multiple times or more just to save $20 bucks. Just buy the OEM one and call it a day!

Fit my dryer perfectly. The install of the heating was easy but the sensors would have been nice to have some instruction paper with them. So far has worked great for the dryer for really cheap and easy fix.

Saved my dryer. Was taken three cycles to dry clothes. Now 1 cycle at 35 minutes all are dry.

Parts were and identible replacement parts and installation went flawlessly.

My Maytag MEDX655DX1 was running, but not drying the clothes. I'm not a technician, but I can operate a ratchet. This kit came with a bunch of stuff. I opened up my dryer from the back. "This bit here looks like this part from the Amazon box." Replaced each one and hooked up the wires as before. Now clothes get dry. Prob saved $800.