KS Hardware, Patent Pending, Adjustable Double Bubble Door Sweep, Draft Stopper, Under Door Seal for Exterior Doors, 1 3/4" x 36", White (36 inch)

I've had this installed for about 4 months now. Summary: It was an extremely good purchase. Enough for me to write this review.This was for a garage side door that had about a 3/4" gap between the sill and the bottom of the door. The garage is heated and it is where we sleep our dogs. I had tried other door skirts and was getting resigned to needing a Door Sock, which you have to move and place each time your open the door. But then I tried this one.What a difference. The temperature in the garage jumped to within 1 degree of the main house, even in sub-freezing weather. Older, less effective sweeps would let the garage fall 6-8 degrees below the house; you could feel the cold getting in, and it was from that door gap.Installation was straightforward. The height is easily adjustable and covers a very wide range, easily closing my gap problem. The multiple bottom seals are very effective and were set to be just-the-right-snug, offering extra protection against pests, which was a bonus.But the big win was stopping the cold air drafts. This item was worth the extra cost. It's hard to quantify in engineering terms, but I''ll bet this sweep is 10x more effective at stopping drafts than cheaper single sweep solutions due to the better fit and seals. At least for me.And my dogs stay warm. Yay!

Perfect fit on my 32” door. Easy install. Screw cover was a tight fit and had to carefully drive/slide it on from the end rather than snap it on. Protected it with a wood block and used a light hammer to drive it. The seals completely sealed the threshold. The outside face is already trimmed to clear the side weatherstrip. The material is a gauge of plastic heavier than most I saw in stores. It’s worth the price for the quality.

I just installed one of these 36 inch sweep/seals on my front door. I opened the door, removed the old sweep (it was just self-clamped on the door bottom), and slid the new sweep most of the way on. Hammering on a wood block on the end got it the rest of the way on. My door is 36 inches overall width so I had no trimming to do. The sweep is all the way up on the door but the sealing is just right. After installing the four screws I proceeded to slip on the screw shield. That was a problem! The shield clamps around the flexible upright side of the sweep, but the side doesn't flex if the aforementioned screws are tight enough to ensure that the sweep stays in place on the door. Even when the screws are loosened, friction is too strong. I applied Vaseline to the door and shield and worked the shield back and forth to finally get the shield installed. But the loosened screws are now useful only to limit possible vertical and lateral motion of the sweep. However, I think there will be no vertical motion problem in my case because the sweep can't be pushed up further, the sweep does clamp to the door, and if it did drop down a little when the door is open it will be pushed back by the force produced by the bottom seals and/or doorway threshold. The only real problem is that if the sweep gets kicked or otherwise knocked, manual repositioning may be necessary.The sweep needs to be redesigned to provide standoff of shield from sweep side and ensure low friction in the slide.Alternatively, a snap-on design may be a better choice.

Easy to install, keeps the water and air out, well made.

This door sweep is easy to install and was able to be adjusted to fill the larger than normal gap at the bottom of the door that other door seals could not do. It has a very clean look once installed and the fit was snug enough that I did not have to use any screws. Just slide it on and adjust it up and down as needed for a good seal.

I liked the concept of this product. I wanted something that would be easier to replace when it wears out than something that requires you to remove the whole door (because it's stapled in). However, even after replacing the weather stripping and adding some form corner door pads, there was still a gap on either side of the door. My door measured 32" exactly but the item was only 31.75" long. We wound up buying the 36" and cutting it down to size - now it's a perfect fit. Do buy one size up and cut it down if you want to ensure the fins are long enough to make a proper seal!

Highly recommend!Works great.. No more critters come and under my door!

Excellent product. Fit nice & tight, & seals extremely well with the existing threshold. I recommend this over anything sold at Home Depot or Lowe’s. There’s even a slip on cover that goes on the inside & covers the screws. No brainer, pay extra for the design & quality.