XHD V2 Front Universal Drive Shafts for Traxxas 1/10 Slash & Stampede 4X4 6851X

These axles broke within a few minutes of running them. I wasn't bashing on them, just on the paved road in front of my house. I didn't make it to the dirt because the axle came apart so quick, I've never seen metal so cheap and soft.

Don't work with stock hubs unless you take out the inner bearing

I did not like how 1 of the grub screws broke and now I have to take them off because I have to hunt down a special grub screw that broke. Keep your stock ones on instead of these.

Okay these are great if you're running 4s and below as soon as you take these babies up to 6s they will snap the only problem I have is the pens tend to break or fall out if this happens go buy you an allen key that will fit the whole and cut it to the right size then Super Glue the silver collar on that I've never had a problem since only thing you have to do

I have a slash 4x4 with a Tekin 4300. Running 17t pinion and 56t spur fear. The fact drive shafts couldn’t handle the power. Put these on and ran it for 30 min. and had if full throttle most of the time and had no problem.

Like them they need to sell a better variety of replacement pins and pin keepers in these sell rebuild kits or just dremel up some small screw I make my own pins and rebuild these all the time saves a lot of money

they lasted a few months on a slash 4x4 vxl stock then axle pins broke. partially my fault because I didn't keep them lubed up like I should. I bought replacement pins and still continue to use them

bought for my VXL Bandit wanted the blue and when i got them i put them on and they don't fit the stock wheel parts..you HAVE to have the upgraded the parts to make these fit...

Très solide mais problème d'ajustement sur un bras trop serer droit et ses le même model que la boite de transmission energy merci

de la le 4/5 2 run en 3s 11.1V 1 de 2 coupé en 2 comme une brindille jai changer l'autre aussi poubelle