BLACKHAWKUniversal BDU Belt (fits up to 52-Inch) - Desert Sand Brown

This is the style of belt I was issued in Basic Training with my BDUs. I like this style because its tightness/looseness can be easily adjusted without needing to use holes, the way a leather belt requires. Its also a tall enough belt to fill in the belt clip/hoop on most pistol holsters.The tag on this thing is marked with "L", which I imagine means "Large." Large is one heck of an understatement, though. I wear a size 38 pants, but this thing wraps 1 1/2 times around my waist! Not complaining, though, as all you have to do is cut it to size, and burn the frayed end with a lighter or some other flame/heat source.Its a great all-round belt, so long as your'e not trying to look snazzy.

These are fantastic cheap belts for keeping your pants up. They aren't strong enough for gun belts. I would recommend a riggers belt for that. But for what they are, they're fantastic. They're also great if you're wearing it under a pistol belt.

This is a very well made belt although a little pricey. I have a 38 inch waist an this belt fits up to 52 inches so there was a lot of belt left over. I just cut off the excess and then fused the end of the belt with a flame so it won't unravel. The belt is made out of fairly thick stiff material and should handle just about anything you want to hang from it. Some reviewers commented about the belt coming loose but I don't see that being an issue. It fits very well in the loops of my Army issue ACU's.

Nice belt for the money. Just cut off the excess

Seems like a good quality belt, but I am not a fan of the buckle. It is a 2 piece metal buckle that can make quite a lot of noise when you pick it up. Add on the fact that it uses the feed through and double back fastening that leaves the loose end on the right, rather than on the left, and this belt has lost me. I don't intend to return it, but I will not buy another in that style.

Always the best belt, it's the one I keep coming back to! Just don't try to support 240 pounds near the front of the belt.. that will bend the small metal tabs on the tensioner and then you'll have to use pliers to bend the metal back..

Good belt, keeps my pants up. Wish it had Velcro so it was secure and couldn't slip.This belt is made in Taiwan, for the folks that like to support work in USA.

As usual my experience with Amazon has been great. I ordered this belt, to go along with a harness system that I am putting together. Many operator belts are very expensive. This belt is very reasonably priced, the buckle is solid, the length is great. The belt is a little on the light weight side, so it may not work for a duty belt, but it works great as an oeprators belt. And as usual the buying experience was fantastic.