EN-D004-12

These are excellent products - I had the misfortune to discover one of the 30 purchased had a visual issue which was resolved with in 24 hrs - very good communications with seller.The damaged was mine to dispose of and I systematically took it apart - there is more going on in these LEDs then in my commodore 64!Current installation is over 19 lights in 3 zones - 6 6 7 what LED Dimmer control do I need?Be careful hereAre your lights on 3 separate circuits as I assumed mine was - but my breaker told me I had 2 circuits,I opened up my current non LED light dimmer controller & checked wiring, yes 2 circuits the "C" is linked between to controllers and only one on the second circuit.This means that I have 19 lamps but in this case 12 7Therefore I needed a 3 dimmer LED controllerI did my research base on the type of LED these are - TRAILING EDGEI Choose VARILIGHT Classic V -Pro but could not purchase the 30 lamp version max per dimmer module the one on Amazon is for a maximum of 10 per circuit so had to go direct to supplier - service as quick as Amazon.Have bought the max 10 one as well but that is for my next project.TipsAre you competentTurn of breakers ! it makes sense,Do your research - that what the Internets for !If you have existing holes check the hole size and how much void above is there do they need to be fire rated?.What existing cabling do you have I was fortunate upgrading a 2012 240v GU10 dimmers scheme - just needed to take them back to choc box connections and recycle.If its new - get a professional and tell him exactly what you want - remember you have plumbing and other power in those voids and it should be certified.Fitting the LED's are a breeze once holes and wiring is correct, very light and easy to work with.The picture shows half way through project - holes, connected and fitted set to Cool White.An excellent product if correctly selected & installed

This is not a complaint, but just a suggestion to improve the lamps.1. The spring load on the arms could be reduced and/or the arms could be lengthened to greatly imporove the easyness of installation of the lamps.2. By fitting leads to the terminals, (as others do) during manufacture would avoid the need for the installer to handle (and lose) the very small screws in the terminals.Yes, there will be a cost for this, but if done properly it would be minimal, and the value of the product would be increased to everyone's benefit.

👍🏻

Good value and service

Easy to wire up and fit, good value, good quality; what more can you ask for?

Good light good price

excellent

Pleased with them.