VideoMic Deadcat Windscreen and Foam Cover - Outdoor/Indoor Mic Wind Cover for Rode VideoMic, NTG2, NTG1 and WSVM Microphone (2 Pack)

Very easy to put on mic and fit well

Good price point. Works well. I see some reviews that says it doesn't fit the VMP+. The trick is to take the foam off the mic. Put the deadcat the foam then put back on the mic. It's tight fit but that is what you want for the best wind protection.

Great, sheds a little, but not too much.

Perfect fit for my NT1-A microphone. Works great to reduce excess noise. Just slide it on and it stays in place.

It fits tightly, which is why there are some bad reviews; however, if you push it on and then pull gently all around, little by little, it goes on just fine. It is thin, which I think makes it less muffling for a crisper sound.

Great pop filter! I use this with my Rode NT1. Fits great. Looks great. Work greats! I've done testing with a traditional-looking pop filter (the thin circular kind that sits between you and the mic) and the dome type (like this). In my testing, this type of filter has performed much better. The other kind may give you the studio aesthetic you're looking for, but for audio performance, there is no

This is a low quality piece of deformed foam, it does not even fit properly on my mic as advertised (Rode NTK). Looks awful. And it is WAY too thick to be used as a pop filter by a musician, unless you want your expensive microphone to sound like a 2005 flip phone.

Quality product but arrives flat and distorted. Run under water for 30 seconds and squeeze out really well and then sit out to dry. It will bounce back to the intended shape and look great on your mic.