DAP Landscape Exterior Filler-Adhesive Foam, Black, 12 oz (7565040440)

Did exactly what it said it would do. I used it for filling in around rocks in my water fall between the EPDM liner and the rocks, and between the rocks themselves for water sealing and for holding rocks in place (as long as they were steady beforehand -- not going to glue a 200 lb rock to a vertical wall). Tried to be a bit conservative knowing it would expand, but even when it over expanded I was easily able to cut it away with an oscillating tool. MAKE SURE YOU SHAKE IT WELL before each use. Also, one trick I saw on-line that worked well too, was in cracks where the foam was to be visible later, I dusted the top of the foam with sand about 5 minutes after I applied it -- the sand stuck and disguised the foam pretty well. I will try and post some pictures later. It is messy, but that is to be expected. Wear rubber gloves and have a rag handy to wipe/cover the end of the tube as you are moving from place to place to avoid drips (disposable rag -- it will be ruined). If you get any on rocks that you don't want it on, I cleaned it up immediately with acetone and that worked fine. The screw on valve tends to come loose, so you need to keep screwing it on, but that is no big deal. I was also able to use the tube storage pin on the valve to close the can for later use, and used it a week later with no problem. Just make sure you shake it well again. It didn't come out of the can as aggressively after a week, but it still worked, and I live in Arizona -- very low humidity. Bottom line is, it works very well for what it in intended for. Those people that have given it negative reviews seem to have tried to use it for something else, or did not read the instructions, or do not understand how foam works.

Appears to be a good product and it should work well.

I was looking for a controllable foam adhesive for adhering rocks to other rocks and the 45Mil firestone rubber liner in the construction of my backyard waterfall. This product was easier to control than other similar products I've tried although I did have to develop a kind of feather touch. The adhesive properties were better than others and it worked just great. Cleanup works well with acetone as long as you use it within about 5 minutes otherwise it is nearly impossible to get off. I dipped the nozzle in an acetone filled cup occasionally to clean it and it worked great to keep it clean and manageable. Wear a new pair of cheap rubber gloves every time you open a new can and clean the gloves with that acetone when you can as often as possible. I went through about 6 cans of this stuff and will probably use a couple more in the tweaking stages. Again, great stuff. Not made for filling bulk areas, this stuff is made for filling cracks approximately half to one inch.

This stuff is a bit of a miracle-in-a-can. #1, It's EXPANDING FOAM people. A little bit keeps growing beyond your expectations. It's a dark charcoal and shiny when it cures. It gets EVERYWHERE--so gloves and clothes you don't care about are a necessity. #2, the directions on it are tricky. I mean, here you are, working out in the dirt and water of your water feature, and everything has to be spit-polished clean. Impossible to achieve. First, you screw on the straw. Then, shake the can. Using it in the UPRIGHT position FIRST, squirt some of the foam where you want to anchor a rock, say. Then, you can use it upside down, or any other direction that seems to work for the project. #3, it sets fast---and keeps growing. You can carve it back with a utility knife, or while it's wet, toss in some small stones to halp hide the fact that you have these shiny, grey, bulbous, alien-looking things. #4, one can doesn't go as far as you think. Oh, and the straw nozzle has a tendency to twist off. Not a great design there.... #5, it does a pretty good job of anchoring rocks, making 'water paths' for better waterfall sound/coverage, and even though it is an expanding foam, it doesn't shift your rocks around. #6, that being said, it will not hold back gravity. If you have a rock that is prone to slide down, this foam probably won't stop the avalanche. #7, it's surprisingly easy to remove from stuff....especially those rocks that we're pristine-clean to begin with. If you aren't happy with the overall outcome, you can pull it apart, peel the foam off and start anew. Home improvement centers sell this exact product, and I have noticed that it is about 1/2 the price here on Amazon. Buy it here.

We had a need to fill a non-structural area on the end of a roof peak vent . The cap was just not there and non were available . The Asian beetles had found this opening they were coming in by the hundreds They look for warmth , well the peak of a roof gets warm . So, out comes the squeeze cheese . Worked like a champ. No more asian beetle issue

Gap filler in a RxR tie retaining wall. Easy application, sets quickly, completely dry over night. Excellent product.

I'm unfamiliar with this type of product, so I don't really know how much to expect out of it, but it was much less than I expected/hoped! It just kept running down the space I needed filled and sinking to the bottom, without really expanding. Unlike insulating foam it doesn't expand out of the can, and seemed to take many hours before it did any real expanding, and was not strong enough to push the plastic liner out at all, anymore than it was when it smooshed down onto the fresh soft stuff. It seems to be good for sealing rocks and stuff together, and might expand right for that, but don't expect it to expand to fill any significant spots. It's not stiff so it will just sag without direct support, and doesn't expand more than maybe 2x the size when "drizzled" out of the can.

Great stuff. Works very well as base for beautiful flower arrangements!

Touch n foam is super easy to use. Make sure you screw the straw onto the trigger well before use as it will pop off making a mess haha. Iv been using it to make a custom background for a vivarium. When I first applied it, it did look a bit flat and disappointing but after a few hours of curing it puffed up great. Cures really hard with virtually no smell. One can roughly sprayed and area of 45x45 cm so if your wanting to use it on a large surface make sure you order a few cans. I can’t comment on the reusability of the product as I had none left over. However judging the look of the can/ straw at the end I wouldn’t expect it to be any good on a second use but as I said I haven’t tried first had. Photos are of semi finished background. I ran out of foam and had to order more but you can see it gives great depth once cured. Works out quite expensive for large areas but it’s way more fun than buying a polystyrene backing. Overall great product that works well. :)

Fantastica ! Ne basta pochissima perché si gonfia molto e poi va tagliata con un taglierino per renderla più effetto roccia! Si incolla molto bene ed e stata per me indispensabile nella creazione del mio paludario, che ormai Ho da 2 anni! Indispensabile davvero !

Very good product . Good option to use with aqascape projects . Mixed very well with stone colors . Strong bonds . Gap filling . Non toxic to live stock .

Parfait pour notre projet .Merci.

Muy buen producto. Lo recomiendo.