Rough Country 2" Leveling Kit (Fits) 2009-2020 F150 | 17-18 Raptor | Suspension System | 52200

Fitted my 2020 f150 perfectly, no issues or problems. My truck looks much better leveled and feels right.

The product is of amazing quality, but the guide isn’t clear and is very complicated to install. The new struts are about 2 inches away from the original ones, therefore the whole shock had to be rotated 180° to fit in the original support holes.

way cheaper than any garage or dealer and easy to install , great price and great product , truck looks GREAT now :)

EL PRODUCTO TIENE BUENOS ACABADOS, VIENE CON SU KIT DE INSTALACION Y MI CAMIONETA FUNCIONA Y SE COMPORTA MUY CONFORTABLE ASI COMO LA ALTURA ALINEADA CON LA PARTE TRASERA.

First off, the instructions get you about 75% of the way. You will need to swap struts left to right, as the leveling pucks change the bolt locations, which if you swap left to right, they will line up with the mounts. That being said, the lower attachment bolts on the struts will be angled away from their original holes, so the easiest way to bolt these on an F-150, is to start with putting the lower strut bolts into the lower arm first, then push the lower arm down and push the strut towards and into the tower, while also holding the UCA up with a prybar. You’ll need a second person for this. Overall, good kit.

Me aparece como que lo devolví pero jamas me llegó! No se si hacer la compra nuevamente! Ayuda !!

Rough Country 2" Bolt-on Leveling Kit for Ford F-150 - This leveling kit fits the 2013 F-150 XLT 5.0 SuperCrew Short Bed. It's the best 2-inch leveling option I’ve found because the leveling kit/spacer includes extra alignment holes that match up perfectly with the strut tower frame—check the pictures for reference. I previously ordered another 2-inch leveling kit, but their holes didn’t align correctly. After installing the Rough Country spacer onto the strut, I swapped the entire strut assembly from the passenger side to the driver side. This made installation much easier, avoiding the hassle of rotating the strut springs 180 degrees. To fully remove the struts for the swap, you'll need 27mm and 30mm sockets. Hope this helps!