Arducam for Jetson IMX477 HQ Camera Board, 12.3MP Camera for Nvidia Jetson Nano/Xavier NX

Paired with a Jetson Xavier and a NVMe SSD and after installing the correct driver, I could shoot very high bit rate h.265 4k30p video :)

The 1920x1080@60fps mode doesn't work on certain Jetson models, but 4032x3040@30fps does.... took some back and forth with the Chinese to figure this out. Also, I can't seem to find any code samples, or instructions on how to get this working with opencv (a non-trivial task).

Does not work with my Jetson Nx unless I change 2 resistors on the board (per Arducam support). This is a documented issue with the dev kit, yet Arducam continues to FALSELY claim it works without modification on the Jetson Xavier Nx dev kit. You'll end up with the board failing to load drivers even though it's plugged in (and there's a /dev/video device). It's an I2C communication failure with the camera board.

Working on second hour of Downloading source files for kernel driver compile and install for raspberry pi. Why in the world can’t we have an apt package for this? Wishing I’d never bought this. PITA

not for any Pi product, could not access code on get hub and jetson requires board modification which i was not going to do for obvious return reasons