HICTOP Ender 3 Thermistor 1.35m/53.1 Inch NTC 3950 100k Thermistor Temp Sensor for Creality Ender 3,Ender 3 Pro,Ender 3 V2,Ender 3 Neo,Ender 3 Max,CR-10 10S,Prusa i3 3D Printer 2Pin XH2.54 (Pack of 5)

This item fixed my problem with my ender 3d printer it works great

This thermistors are just what I needed, seem to be good quality, it took me 10 min to install and they work just like oem product, cables are long enough for my printer and they come with the terminal plug already installed only time will tell how long they last but for the price point they are a steal.

Arrived VERY well bundled. All probes perfectly wrapped together with single rubber-band holding them together. I pulled the one out of the bundle that I needed, no tangles at all.Also, while likely not needed, it arrived in one of those anti-static plastic semi-transparent grey colored bags.Got this because my Ender 4 factory bed temperature sensor failed (randomly started getting "mintemp error".*Note: the factory probe has the wires built into the actual underside of the heated bed. Because this has good length cables, I simply used Exacto knife to cut away old probe in center of my heated bed, grabbed needle nosed pliers to remove old probe, then put new probe in that hole (not sure if I am supposed to fill that hole with thermal paste perhaps...). I simply put it in place using some all weather high temp clear tape, and also used same tape on underside of heated bed to hold the wires, then zip-tied the wire along the existing heated bed wiring.*note2: Excellent length. It is actually longer then needed, but honestly... WAY better having a little longer then to short. Can always wrap extra together and zip-tie it if needed (but it is not super long so really not needed).

First - if you need a Thermistor for your Ender 3v2, get the 1.2 meter length. The 1 meter length is not long enough. My printer Z axis is now limited to 3/4 normal height until I get a replacement. This is my fault, but I wished I'd know.Second - five thermistors come in a package and instantly display their freedom by becoming spaghetti upon opening. Because they are loops, you cannot simply find an end and pull it out. Ohhh, no, other wires have found their way into the loop, making it a brain-teaser puzzle. Took me 1/2 hour just to extract one. It would be nice if they came in individual zip-bags or wire-tied individually so all five don't gang up on you at once. If you order a bundle like this, find a trusted friend, and VERY carefully straighten one fold at a time while your friend pins the rest of the squirming wires to to a table.

Addded a new one to my printer and worked again

I had the bed temp sensor go out on my Anet A8. Ordered these to replace the one thermistor. I have it working now - but there are two issuses.1. the plug doesn't fit my control board. Not a big deal. I just cut the end off the failed thermister and soldered it on.2. These won't work with the stock temp sensor on the hot end. Even though my hot end thermistor was still working, it wouldn't work with these. But, all I had to was replace both the stock hot end sensor and the stock, broken, bed sensor and now they work together.

I finally got a seller that knows which thermistor fits the Creality Ender 3 V2 Neo. Thank you so much. I had to send 2 others back to other sellers that sent thermistors that would not work. Thank you again. I will buy from you again.

I spent 20 minutes untangling the thermistors so that was really aggravating and I feel it could have been avoided. However everything worked very well and at a great price.