Made in USA 1 Inch (25mm) Round Rubber Plugs for Holes (20 Pack) - Flexible White Rubber End Caps - Hardware Plugs - Metal Tubing Post Cover Protective End Caps for Furniture

Work good on round legs

In order to keep my dogs from eating the cats' food, I used one of my child gates to block off the room. Unfortunately, my older cats couldn't make the leap to get over the gate so, rather than buy a new expensive gate with a cat door, I simply cut one of the bars to make a hole. I needed something to cover the sharp edges left behind by the tubing cutter and these end caps were a perfect fit! I used super glue as a back-up just in case, but honestly these popped on well and were good and snug even without the glue. Their thickness is pefect, keeping them sleek rather than bulky but still sturdy. I liked these caps so much that I bought the 3/8" ones for the hallway gate when I cut it, too.Now the cats can easily access their food and I don't have to worry about them getting hurt on the cut edges. Great product!

This fit for what I need it for. I hope that the thickness holds up

Since I live in the Northeast, I have to mark the edge of the driveway for the snow blower. Instead of simply putting the snow stakes in the ground, I drove conduit in the ground and simply drop the snow stakes into conduit. I capped the conduit with the rubber caps so that the sharp edges are covered. Just before winter, I simply remove the caps and drop the snow stake into the conduit. They have been exposed to the weather for two full spring, summer and fall seasons and just went back on for a third spring. They have not lost any elasticity nor have the cracked or deformed in any way.

Used 1/2" Conduit and clamps mounted to the acoustic ceiling grid to create camera/lighting bar mounts in our training area. These Caps added a nice finished touch. The ID was a bit large, but a couple wraps of electrical tape made for a snug fit.

Exactly what I wanted. Good quality

I've ordered two sets of these caps and they are too small to fit over the end of a 3/4 inch OD PVC pipe no matter how hard you try to stretch them. There's something wrong with the labeling on these packages. I can't tell for sure but they may be caps for a 1/2 inch OD pipe.

The end caps fell off the legs of my fan leaving a sharp metal edge. These plastic caps fit perfectly. They go on nice and easy but are secure enough to not fall off.