Metra 82-7400 Speaker Plate Fits Most 6" to 6.75" Speakers in 2000-UP Nissan/Infiniti Vehicles

FITS LIKE A GLOVE! These things are not much flexible but it flexed slightly to sit flush into my doo speaker area so there wasn't any slight openings They fit on my Nissan 350z AMAZING!

great mount works on 2019 Mazda cx5 sport non bose like a glove

I bought this kit for my rear door speakers on my 06 Titan king cab due to the factory speakers being permanently mounted to their brackets. These work great and have the speakers sitting at about the same depth as factory. If you are wondering, you do not need these for the front door speakers. They're 6X9s and a new speaker can go into the factory mounts.

Made for a really clean factory fit and install. Just had to spin the adapter around till the holes for the speakers would end up being in the correct placement. Even, though being being the door cover. Not going to see if the speakers aren't straight. But, I like to take the time to make things look correct. Then, I marked a spot to run the metra harness adapter. Drilled with a 3/8 drill. Able to run the harness wires close to the factory location. Really impressed by their products. Made for factory like easy install.

Perfect fit for my 2017 Nissan versa note

Recently bought a new 2023 Kia Niro EV, the HEV and PHEV all have the same basic body chassis and sizing. The stock audio system is pretty dismal if you don't end up getting the premium Hardon Kardon system. The front doors have 6.5" inch woofers with separate tweeters, the rear door have slightly smaller than 6.5" inch, but can fit 6.5" with a different modified speaker adapter. The Niro uses three screws in their speaker bracket, the stock speaker bracket is also raised off the mounting surface just like this one to give you a little more depth. The front doors are a bit shallow with the windows down they do partially encroach into the speaker space so you definitely want to measure and go with shallow mount speakers or magnets and spider baskets that aren't too wide. There's also door molding parts that encroach into the speaker opening preventing large woofers from fitting. The three mounting brackets tabs on the adapter are in the correct place but the depth where the screws fit is off, so you have to drill the the tabs so the slot is deeper and right up next to the raised ring (see pic). Do that and you're good to go. Otherwise the Metra Universal 6.5" speaker adapter should work once you break away the inner tabs, this adapter also fits the rear doors but you need to drill holes into the three divots in the ring as all the other tabs are useless. This Metra 82-7400 speaker adaptor will NOT work for the back doors as the mounting hole diameter is smaller and nothing lines up, even with modifications.

These worked well with the kicker speakers I purchased. They were to retrofit a plug-in place speaker in a Mazda sport 3. As described they worked well. Four screws which came with the plate.

I replaced speakers in a 2015 Mazda 6. The original speakers come in a non detachable housing, so this adapter for the new speakers is absolutely necessary! With the Red Wolf speaker wire harness, which I bought separately from Amazon, all I had to do is install the speakers into this adapter, with some sticky speaker tape to fill the small gap between the adapter and the speaker, as well as between the adapter and the car body. Plugged in the included wiring harness and I was done! The most tedious part was taking off the door panels and putting them back one.

Se acoplan excelente a mi auto y bocinas

Fit parfaitement pour un Nissan Rogue 2020 speaker avant porte.

Excelente, le quedo perfecto a una Pathfinder 2013 en las puertas traseras