Tekonsha 7686 Prodigy Brake Control Mounting Pocket Kit, Fits Prodigy and Prodigy P2 Brake Controller (Not for P3 Controller)

As others have noted... The P3 does not fit into this mounting pocket without some slight modification to the pocket itself. At the rear of the pocket, there is a little 'step' in the plastic to provide clearance for the connecting cable plug for whatever unit is intended to go into this pocket. But it's not enough for the P3 -- its plug is further to one side (the wrong side) and once the connecting cable is attached the P3 will not slide all the way into the pocket. You must shave off an approximately 1" x 1/4" piece of plastic from the rear in order to provide clearance for the connecting cable and its plug. I used a utility knife with sharp blade and removed the material a sliver at a time, took about 10 minutes to remove enough to allow proper clearance. Also the two clips on either side of the mounting pocket do not align with the two holes on either side of the P3 -- not even close. That doesn't seem like it will be a problem -- the P3 seems to be held quite securely in the pocket just from friction alone. I'll be mounting mine with the P3 facing upward, so gravity alone will be good enough for me. This pocket is -- in my view -- far better than either bracket that came with the P3, if for no other reason that it has an approximately 3" x 2.75" flat surface where I'm going to attempt to use sticky-back velcro to mount it to the car. I really don't want to put screw holes into my nice new car if I can avoid it. Time will tell. I'd give it 5 stars, but will deduct one for Tekonsha's failure to provide a bracket that exactly fits the P3

Needed a new mount for my Prodigy P2. This housing fits right into the pocket of my center console pocket in my truck to secure the unit. Works great.

This is a great product for removing your brake control, and being able to use it in multiple trucks without buying controls for every truck! You just unplug the unit and pop it out of the pocket, and put it in the other vehicle. Or you can just remove it to avoid theft if you like. I would have given it 5 stars if it weren't for the somewhat unfriendly mounting holes. The design seems to assume you are drilling holes for the first time rather than trying to line up with holes that have been drilled already, as so many trucks have. The old-style metal brackets have slots so you can line them up with holes, but this not only has pre-drilled round holes, but they are in grooves as you can see, so you can't even really drill a new hole in a different place. I had to take my power multi-tool and cut a slot between 2 holes, and then grind down one of those raised ribs between holes, to line up with my pre-existing holes. I'm sure other people like me don't enjoy then idea of drilling any new holes in a nice truck when there are already some there. Other than that, it works great and is easy to use!

Just what I needed to help transfer my controller between vehicle's

Works fine With my P3,had to trim a very small amount in the back with a blade for the plug in to snap in place,simple task.Thank you

I have a breaker controller in my SUV and wanted to use the same unit in my RV. Works as designed. Mission accomplished

Fast ship. Product as described.

Works as expected.

Works as expected

worked perfect, easy to mount

Fit my unit perfectly and super fast shipping

Just as described Fit my p2 perfectly.Thanks