MARS - Motors & Armatures 11952 Round OEM Mars2 Start Capacitor

I purchased this to replace my 10” Rockwell Unisaw’s capacitor. Motor was just humming and not spinning. Checked the voltage at the low voltage box. Everything checked good. Removed the motor and smelled it. Nothing burned. Removed and tested the capacitor. Read 0 (zero). Was a little apprehensive to just replace but what else could it be..... So, replaced it and all is good. Saw is working. Only item noted was the physical size. Much smaller than what I removed. Hoping the duty cycle is equal to what I removed!

I used this for an electric motor on my compressor - worked perfect!

Replaced a bad start capacitor in my dehumidifier. The old one was a 200-240 uF 250V. This new one rated 216-259 uF tested at 235 uF and the dehumidifier is now working again. The compressor would just hum when turned on pointing to the start capacitor as the most likely problem. Sure enough.

Unfortunately for me,I smoked this unit immediately because I didn't check to see if the centrifuge doomahicky inside the motor didn't disengage once the motor started spinning so the juice just keeps feeding the unit electricity. So everyone, just need to check if the contacts will release. Don't assume

Turns out, this was not needed. Tested it for future use anyway. Tested just as it should. Good quality ... good price.