PC-Super Epoxy Adhesive Paste Kit, Two-Part with Dispensing Gun and 3-Pack of 50ml Cartridges, 03589, Clear

This epoxy is unbelievable. I am replacing my 55 wooden stair balusters with 1/2" square, hollow wrought iron balusters. I was concerned about my new square balusters staying tight in the existing round hole where the old wooden balusters were. I have replaced 23 so far using the epoxy on just the bottom and I used just one tube of epoxy. I used about 1/3 a teaspoonful of epoxy on each baluster. I used Loctite PL MAX Premium on the top just to save money. I couldn't be more pleased. Although, you need to give the full 24 hours to cure, they seem rock solid after 12 hours. The dispensing gun is a must. I am a believer for life. I have already bought four extra tubes! You will not be displeased if you buy this product.

If you need strong epoxy to get a project done and never look back. This one is it

The instructions were not great and the gun oozed more out of the back end than through the mixing nozzle. I had to throw it away and go to Home Depot to buy the regular epoxy and mix them by hand and apply. I highly not recommend this product as you’ll be disappointed.

Damn nice product! The epoxy and gun are the best of the best! If you have a project that requires more than what comes in the little packets or the epoxies that you have to mix by hand this stuff is the ticket. I can use a whole tube and come away without having the glue all over me. It's the "Harry Home Owner's" equivalent to HILTI.

Waste less can you can use it for the second time

I ordered a bag of like 100 replacement mixing tubes so that I can use just a little bit of epoxy for whatever my use case, toss the tube afterwards and clean up the lid & dispenser holes before putting it away, and have epoxy ready to go again on a whim

The epoxy flows great , but the dispensing gun locks up and becomes unusable.

Used to bond the base of metal spindles to wood. Worked great. Highly recommended. Absolutely solid for this job.