NACX Ball Plunger, Ball Detent, Spring Plunger Screw, 10Pcs (8 x 9, 12N)

I picked up the 2x3mm one for a case project I'm working on. I'm actually surprised how well these work given the size of it. How is that even possible?! I give this 10/10.

Fit good, works good

they work fine and plunger is not sticking

These work well for 3D printed parts such as slide latch lids. The prints do need to be thick enough to support these tiny parts so they don't punch through the plastic.

bought for small project, they was easy to install and fit correctly. good value

They work great and a firm lock rest, fast deliverThanks

Under no circumstances would I ever use these thingsagain, or anything made by this company. I measured my oiler hole with calipers. It is 6mm. They say these are 6mm. They are not. I put one in and it went right to the bottom of my lathe cross slide. I literally spent almost two days trying to get it out. I had to completely disassemble the lathe cross slide including dropping the cross slide gearbox and removing the drive rodsThese are a nightmare!! DO NOT USE THESE UNDER ANY CIRCUMSTANCES unless you enjoy colossally wasting your precious time. Even the flange on top which is supposed to keep them from dropping into a hole is way too small

These are just as advertised, no complaints on my end. Arrived quickly.