ELEGRP G1215PA2 G20PASR Patented Auto-Monitoring GFCI Replacement Plug Assembly, Auto Reset 15 Amp Non-Grounded 2 Wires 2-Prongs for Power Pressure Washer, Pool Pump, UL/CUL Listed, 1 Pack, Black

This was exactly what I needed, and worked just fine. Fits like OEM. It was pretty easy to wire up and included various sized grommets for different sizes of wires.

This was the exact replacement for my Electric Pressure Washer. My washer stopped working where I debugged it down to the GFCI plug that failed. found this one on Amazon as a direct replacement. Installed simply and it worked! My pressure washer is back at work.

Simple, direct replacement for the original. Works as expected and actually seem a little more higher in quality.

This was a perfect replacement for Ryobi pressure washer. In the old one, there was a buzzing sound coming from the plug. So I purchased this. It was easy to replace, came with all the necessary parts. It probably took me 10 minutes from start to finish and now my pressure washer is working perfectly.

A good replacement for my hot tub power cord. Took 5 minutes to install, and has been working flawlessly for 2 weeks. Be aware that this plug is NOT waterproof. I’d go so far to say the water resistance is sub-par. The rubber gasket that is supposed to seal around the incoming wire would not fit. The installation leaves seams that are not sealed with gaskets. To compensate. I covered seams and power inlet with a silicone sealant - that should keep any moisture out. If it does fail, the price point was good, so replacing it isn’t an issue.

Went to use my electric pressure washer and it was DOA. Checked everything I could think of including the plug GFCI. It clicked when I cycled reset and the green light was on, but I became suspicious when the test button did nothing when pressed. Ordered one of these and it arrived the next day. Connecting it is simple. Washer now works perfectly. A couple of unrelated lessons I've learned; always disconnect the pressure hose at both ends for storage so the pump can drain and use a pump lubricant spray once in a while.

The plug on our Sun Joe power washer burnt out so I swapped it with this and it’s working like new. Perfect fit and easy to install.

Our new hot tub ( Dr Wellness) came with a manual reset GFI , when power went out you would manually have to hit the reset button-not good in a cold climate. This plug was perfect, resets by itself in the event of a loss of power - Exactly what we needed .