89341-0C010 Parking Sensor 89341-0C011 89341-0R030 89341-0R031 89341-0R060 for Toyota RAV4 Tundra Tacoma

Worked great - Installed and it fixed the issue

These sensors are great. I had good luck with the one I purchased a year ago and decided to buy two more to replace some other not aesthetically pleasing sensors. They come with the part that locks into the bumper as well.

I was hesitant to order this - seemed like it may not work. But given the Toyota OEM is around $170, I thought I’d give it a try. It worked! A little cheaply made, but it works. We will see for how long.

On my Tundra for reference.Fully submitted to having to spend $170-$220 at Toyota to replace this. Simply wanted to give it a try as the price was ridicules. It been only 6 weeks but that is in Phoenix 110+ degrees and is still perfect. Even gone through car wash a couple of times.

Can buy 8 of these for the price of 1 genuine TOYOTA OEM replacement on a tacoma. That’s a naw for me dawg. It fots in the hole. It doesn’t wiggle. It’s the same looking composition as the factory sensor. It seeeeems like a good deal. We’ll see how long it lasts. I’ll have to go get it calibrated or whatever at the dealer. But it fits perfectly.

This wasn't an OEM part, thought I'd save a little money and try it, unfortunately, fit wasn't great but then didn't work at all. Waste of money. Bought the OEM part and fit perfect and worked! Go figure!

Toyota wanted $170 for part and install. Took 20 minutes to install and then a few days for the sensor to react to the system. I disconnected the battery for 1 min then connected. Make sure you look at how the clip that holds it in place is sitting before you remove it. If you don't, you'll be there a while installing .. trust me

My OEM blind spot monitor was not working. Replaced it with this item which is a fraction of the cost of OEM. When I first hooked it up my Tacoma still was saying “not available”. I drove with the monitor on for about 25 miles and then it recalibrated and is working as it should.