Parking Reversing Sensor Kit with 4 Sensors and Audio Buzzer in Black

What a great product. Installed flawless And the supplied cutting tool for the bumper made the job a breeze. wiring was very easy and most importantly it all works, I defy anyone to know they aren’t factory fitted sensors. I did actually re-spray mine from black to the silver colour of my jaguar and they work fine, I just did a couple of light coats and dried them on a gentle heat with a heat gun. Highly recommended for the price. Also the description and photos show the word ‘buzzer’ for the sound device but rest assured it’s a beeping tone like all the factory fitted reverse sensors I’ve ever ‘heard’ and works brilliantly.

at this price you may think that quality is an issue, but these sensors are every bit as good as factory reversing sensors, I had mine fitted for £50 because I couldn't be bothered to fit them myself, and I put some duck tape over the buzzer before they were fitted because I read that some people who bought these thought the buzz sound was a little too loud. All I can tell you is that they work perfectly and it makes such a difference having reversing sensors on your car. money well spent, no fuss, low cost solution. I would not hesitate to buy another set of these for another car or for friends.

I ordered this set on Sunday afternoon & it arrived Tuesday,excellent service & well pleased with ease of fitting & end product,sensors are well made,the only tricky bit was feeding sensor cables behind bumper into a factory drilled hole into the boot,check & double check measurement for holes that need drilling into bumper,I tested all sensors individually before drilling holes,and making sure I had a good earth/ground connection in the boot,have saved myself a small fortune for good quality parking sensors,will be buying another set for my van !!!! Money well spent

I used these to replace existing OEM sensors. I tried buying exact replacement originals but the ones I bought just didn't work (the car is 17 years old so it is hard to find the right bits now). These don't clip in like the originals but a bit of electrical tape soon made them wedge in tightly. Trickiest bit was feeding the new wires from behind the bumper up into the boot. You need to find a suitable hole, maybe where existing wires go through. Then you need to splice the power lead into the reversing light wire with a Scotchlock clip, stick the main unit and the buzzer somewhere convenient - unit behind some trim, buzzer in the boot and finally stuff the excessive amounts of remaining wire behind the trim. I would allow a couple of hours for fitting, much of which is removing and replacing trim in and around the boot. Invest £10 in some trim removal tools to make it easier, Silverline are fine. They work perfectly, a short beep when you select reverse to show that they are working, slow beeps as you approach an object, faster when you are near then solid beep when you really need to stop. I would buy again, although I hope I never have to.

Ok, very hit and miss, good for the price but nothing like proper manufacturer sensors.

Fitted this kit into my sons Toyota Yaris a couple days ago. Planned the route for cabling & where to install the control box & buzzer & also checked for any obstructions or cables behind the bumper before drilling holes out. I purchased a separate inline fuse holder & soldered that onto the Positive feed cable as there is no protection for the unit, or the car lighting system in case of a fault. Went in easy & all connected up like a treat. The buzzer is loud.....i mean VERY LOUD so if you are going to mount it in the boot or fix it to the side of the boot etc you may want to stick a little piece of insulation tape over it as that will muffle it enough to still be heard. Ours went behind a panel so didn't need muffling. I fitted our control unit & buzzer behind the nearside light cluster as there is only one reverse light on this car, and all bits, cables, unit & buzzer are accessible by removing the little plastic access panel at the side of the boot. It's very audible where it's fitted. Not too loud to annoy neighbours in the middle of the night & not too silent that you can't hear it. Altogether a great item & easy to fit. Only thing i can maybe say negative about it is that it could have come with an inline fuse pre-fitted for protection which wouldn't break the bank.

i have a refund request in place for this item right now. First of all i am a qualified auto electrician in plant so more than qualified to fit this kit , and i saw this kit thinking it was generic from the same factory line as the uk branded parksafe product which i have fitted many a time but that kit is twice as expensive (ecp) and realised on arrival that this kit is of a cheaper construction. anyway connections soldered to loom the correct way ( not with supplied scotchlocks uchhh) anyway seen mostly good reviews so decided to fit it to wifes new car and the overall look of the sensors are fine. worked ok for about 10 mins but now mostly false alarms constant on and is very annoying and defeats its purpose if it doesnt work reliably So there i have it fitted and is useless and have requested a refund and have been sent the details to send it back which is nice , but i will be left with 4 holes in bumper in theory. So basically i have to commit to buying another kit such as the ones ive used before and fit that again , remove this kit , so for all the faff and wasted time in hind sight i should never have bothered with the cheaper option. if seller is reading this i would at least like the option to contact yourselves and try a new box or sensors