MODIFI3D 3D Print Finishing Tool

works well, only 1 temp which means it can burn the hell out of PLA but also means it cuts through quickly. Couldn't get it to work with a battery pack so using it in the garden was a no go (melting plastic gives off fumes)build quality is so so, the simple body can feel a little cheap but it is strong and works really well, the tips all work fine but some take a little getting used to. this might be a great tool for ABS but i haven't done an ABS print yet.All in all this is a really good product but unless your using a lot of support material and your slicer is sticking it to the model too hard then this isnt a 'must have' but still really good to have incase.

Had great hope for product, but its flimsy and doesn't get hot enough, may be useful for some minor work and has great potential but not for me

all good

Lasted a couple of weeks then just stopped working.Loved the idea but not robust enough.

Its ok, its effectively a low powered soldering iron with different ends.... It does the job, but its difficult to tell where the support ends & the finished part begins.