CIARRA CBCB6903 60cm Visor Cooker Hood Undercabinet Hoods Wall Mounted Kitchen Extractor Fan 600mm Top Vented Range Hood

Used under a cabinet using the recirculating air mode. Fairly easy to install. You do need a second person to hold the unit in place whilst marking where the holes/screws are to go under the cabinet. The supplied screws are too long for this installation and would breach the inside of the kitchen wall cabinet if used. I used my own screws and as the metal casing is fairy thin I also used a washer to give the casing more support. Good product, easy to use and does the job it’s intended to do.

Good value extractor fan with good LED light, does a good job.

wanted a slimline black visor hood,, at only 80mm high this was ideal. Firstly this is a smart looking hood, despite a couple of reviews saying it’s a bit flimsy, if screwed into the bottom of a bridging cabinet rather than attached at the back it is much sturdier. Would have gave 5 stars but a couple of niggles. Firstly, and this might not be the case for everyone but I had to drill 2 new holes in the top as the pre drilled holes aligned with the metal fixings on bridging cabinet, easy remedy though. Secondly the electrical lead has a kettle type adaptor, so if routing it through the back of a cabinet you need to drill quite a large hole

Great as don’t need an outlet. Looks great

Love it perfect for what I needed 10/10 easy to fit!

This seemed ideal to replace my faulty Electrolux hood but sadly when it arrived and I unpacked it found the metal casing feels much thinner and the tabs for opening and closing the grill again feel like very cheap plastic compared to my existing one...to top it off there was notable dent on the front top edge which meant I have had to send it back. Well recieved the replacement unit and must say while it does the job installing it was a right old faff. the extractor outlet is actually closed of with a disc of metal the same as the rest of the outer casing this is actually welded in place by 6-8 tiny spot welds. I managed to pry it apart using a large screwdriver but given the thinness of the casing material do thsi too roughly and you will dent the unit (wouldnt be visible if attached to an overhead bridging cupboard unit but thats beside the point. Then there is the factory fitted plug which cannot be removed- far from ideal if you want to thread the cable through a single drill hole to reach a concealed power point.....I did end up dismantling the unit to see if I could remove the cable from within the unit and loop that through the hole and reconnect it but the two pin terminal that connects internally to a circuit board was too wide so I either had to make a bigger hole in my cupboard or cut the supplied power plug off and loop the cable through the hole to reach the power point then install a new plug of my own. Suggest paying a bit more for a more robust piece of kit.

Easily fitted, sturday, powerful suction, if a bit noisy. Pleased with my purchase

We have not had a cooker hood before, works great, reduces fat smoke and cooking smells pretty well. Down side it doesn’t look as fancy as some but it is a reasonable price and does what it claims !