5pcs 10X25mm(0.39x0.98in) Super Capacitor 2.7V 10F Farad Capacitance Winding Type Energy Storage for On Board Backup Energy Storage

I used this capacitor as a signal buffer curcuit for an old gas gauge that was bouncing all over the place. It works great as a buffer curcuit and it took out the constant fuel gauge fluctuations while cornering and driving to to the fuel gauge inside the gas tank.

Worked for og Xbox clock.

My LiftMaster 885LM wall control conked out. After some research, I found that a pair of capacitors in the wall control were a common failure point. Ordered these capacitors and they arrived next day. A few minutes to remove the old, solder in these new ones, and.... I was back in business. $10 beats the heck out of $70 for a replacement wall control. And, I now have spares should they fail in the future. Very happy with my purchase.

These caps are perfect replacements for Davis Instruments ISS devices. Replacement is simple... snip out the old one and solder in the new one to the wire stubs left in the ISS. Works perfectly and restores operation of the weather instruments!

Perfect solution for my failing Liftmaster 881LM. Replaced the caps, powered up and a minute or so later, the garage door is back to normal.

These work well as replacements for the dreaded clock cap that leaks and obliterates components and the PCB around it. It functions very similarly to the original component in terms of duration it will keep time when unplugged.

Used these to make a battery (BCR) replacement for 0 gauge model train MTH 2.7volt. Two of these in series with a Zener diode 2.7V 5% 500mw from lower negative to upper positive of the series capacitors and shrink wrapped. Works great. For 8.7 Volt use 4 of these caps in series with same Zener diode across all neg to pos (using 4 diodes)

Used to replace original Xbox clock capacitor. Easy fix and works great!