SOULWIT Protein Leather Headband Cover for Audio Technica ATH M50, M50X, M50XWH, M50XBT, M50XBT2, M50S/LE Headphones, Replacement Headstrap Pad Repair Part (Black)

Great product

Assolutamente adattabili alle cuffie rovinate

オーテクのATH-M50xのヘッドバンドが加水分解でボロボロになってしまったので購入。 かなり簡単に交換できて感動しました。 ドライバーと詳しい説明書も付属するので、これだけ買えば誰も簡単に交換できると思います。 仕上がりのキレイさも申し分ありません。 またボロボロになったらリピートします。

The replacement headband was super easy to install, it's well-made, comfortable and looks good.

Fits well, pretty easy to mount. Quality seems fine, gave new life to old headset!

I looked forever to find this product, black, but for the ATH M40. It just didn't exist in any color other than brown (ew). So I bought this one, which is for the ATH M50, and it fits just fine. Anyone who doesn't want a brown replacement cover for their black ATH M40s, should consider just buying this one instead. The one main negative to this product is in the installation directions. They aren't great. Despite that, I was able to do this in less than fifteen minutes. Anyone with enough patience and skill can manage this if they take their time, use common sense, and carefully observe how the old one was put together. Everything you need is included, even a piece of tape for the headphone wire and the screwdriver you need for disassembly. Removing the old one was simple, and getting the new one on was only slightly tricky. This could be due to the fact that I was putting an ATH M50 cover onto an ATH M40 but they're so similar in size that I doubt it. It's just a bit of a tight fit, which is necessary to preserve that factory look. Practice getting the alignment right before you remove the backing from the tape. Once you stick the tape onto the headband, carefully stretch the fabric around the band until the foam section is correctly aligned, stick the velcro together, and reassemble. I had to manage the wire inside the headband and make sure it didn't get pinched during reassembly, I don't know if that would be the same on the ATH M50. I assume so, because there is a piece of tape in just the right spot for you to stick the wire on to hold it still. The tape isn't super-sticky but it doesn't need to be; the velcro is doing the heavy lifting there. Despite being used for headphones not in the recommended list, fit and finish were just fine. The material feels about the same as what I replaced, just typical pleather over a thin foam cushion. The foam is thicker in this replacement than what was originally in it. That's a plus. And, the color matches. After installation, the headband replacement looks like it belongs there. It looks really close to factory, actually. It only lacks the brand name logo that the original had, and I don't care about that. The cushion is slightly thicker, which adds a small amount of comfort to what was already a comfortable-to-wear headphone. Looking at it now, no one can tell I've had these for almost a decade. Very pleased with this product and would recommend.