DAP Touch 'N Foam Professional Wall & Cavity Spray Foam Sealant: 185 sq. ft. Yield / 20 lb.

I paid over 300 for this dap spray foam and it was worse then if I used individual cans. Spray came out in stream and I reiee adjusting tip and wand control. I even shook it a second time. No matter what I did it was clumpy and would not spray in the wide pattern as in the pictures and made a mess everywhere lucky i had plastic down as the thick pieces kept dropping to the floor. I got only 100 sq ft xoverage not the 185 as about 30 sq ft endes up on the floor. Now i have to go buy can foam spray to fill in the gaps. Very unhappy with dap.

The wall cavities in the left I used froth-pak sealant 200. I had one wall cavity left, and frtoh-pak doesn't offer a smaller size, so I went with this brand to finish up. The picture speaks for itself. Granted it could have been user error but I followed the directions. Maybe I should have checked the tip? I'm not sure, either way I wasted $200. Would work great for filling large gaps but not for insulating wall cavities

Product doesn’t mix properly out of one tank. It’s pretty much junk. Use the 2 part/tank product. Everything I sprayed fell out of the cavity due to the improper mixing

Absolutely does not spray a wide pattern or cover well. Just comes out clumpy. Total waste of money.