UniqueMe [2 Pack for Samsung Galaxy S23 Ultra Privacy Screen Protector, [Dust-Free Kit] Auto-Positioning Bubble Free Easy installation 3D Curved Full Coverage [Not Glass][Support Fingerprint]

Surprisingly impressed. I am a huge whitestone dome fan, but had 4 crack in the last year from minor impacts so wanted to try something a little more value oriented. Installation kit is very good, installed first attempt, no bubbles or dust, alignment is spot on. Includes everything needed for 2 separate installs. Great overall. For the first few moments the cover looks like and feels like it retains more 'finger grease' than glass (when screen is off/black). But after light use for a few minutes it feels the same as glass. Can see no streaks or marks at all when screen is on. Cant yet speak to durability, but nothing to indicate a cheap product so far.

Anything less than 5 stars for this product would be criminal. Since the Note 4 it has been an A nightmare buying screen protectors due to the curved screen and nothing lasts very long, so far so good with this product. This has been by far the easiest screen protector to install dust free and I've installed a lot over the years as I replace them as soon as the oleophobic layer fades or the protector lifts of or has imperfections. This allows for easy dust free application. It feels just like the glass and is very easy to clean. I am using a Mous case and to ensure it doesn't lift it's best to leave it a couple of days either without a case or if you're not totally psycho then get a case with smaller edges so it doesn't lift and then put your case back on. It may lift on one side every now and again but I just simply take the case off and press it down again and haven't had any issues with it. A small niggle on an otherwise great screen protector. No issues with clarity, fingerprint reader or sensitivity, in fact, didn't even need to recalibrate or re-register finger prints from last screen protector. This has been a revelation, so much so that I bought a second pack just in case as a lot of companies seem to disappear. Cannot rate this protector highly enough.

Went on smoothly, but leaves lines all over the screen, complete waste of money

I bought this as i ended up getting a super fine chip in the screen on my new Samsung S23 Ultra phone as i just couldn't be bothered installing the expensive protector i bought at the same time as the phone because i just knew it would be a nightmare. I just kept putting it off. DONT, just get this. The system made it so simple to apply the protector and it looked amazing, no creases, bubbles... nothing. Everything was just great. Then i stuck the phone inside my Spigen case and the next day the top left corner was lifting, I’ve tried everything other than completely removing it and trying a new one, but it still lifts. I'm going to guess initially the protector is just a tiny bit off on the top left side (or it’s the case that is off a little) and as the S23 has a curved screen it just binds on the case at that corned thus pushing on edge of the protector slightly and it peels up. So, not going to blame this product for what’s happening as I’m sure it's caused by the case. System is awesome and would definitely buy again. BTW, it would be amazing if you could buy the protectors on their own????? since you already purchased the install device ;-)

Best phone screen protector I've ever owned to date. Easy to install. Hasn't cracked or chipped yet, despite dropping my phone accidentally a couple of times. No complaints.

I actually bought this about 18months ago. I work in construction and just have a body shield type case with nothing covering the screen. I do a lot of raking out and pointing and plastering, and there is usually grit or dust in my pocket. When I was choosing a protector, I found most of them mentioned uplift around the edges and this product seemed to be the best of the lot. I did find installation a little tricky because I didn't want to mess it up and overthought it a lot. However it stuck really well and covered top to bottom and side to side perfectly, with no glass left showing. The applicator also does a great job of lining everything up and ironing out bubbles, although the lever is quite stiff. Within a week or two, I'd got lime or something on the screen and gouged a hole in the protector. For some reason, I didn't take it off and out the other protector on. Over the last couple of months, the hole has worn a bit and so I decided it was time to put the new protector on. The fingerprint sensor can be a little tetchy with me, but that is usually down to me. Lime dries my hands out so my fingerprints get a bit shrivelled. It usually takes a day or 2 off site for it to know who I am again. I have found that a bit of hand cream or moistening my fingers generally helps this though. Taking the old one off, it was still incredibly well stuck down. I also found that the hole in the protector only went about ⅓ of the way through and the screen itself was still protected. I do have three strange lines across my screen which look both like stickiness residue and also scratches, so I'm going to give it a good clean before I put another one on. I'm not sure if I misplaced the instructions or if it didn't come with any. Either way, I went to put on the 2nd protector and couldnt quite remember the process. I put the phone in the cradle and the protector on its jig, and stupidly didn't check things were aligned. I'm not sure if my phone was sat too low, somehow (I didn't think there was any room for error, but I messed up somewhere) or if the protector tab was sat too high on its jig. Either way, the protector was overhanging the top of my phone and falling short of the bottom by about 5mm...... but I'd already pulled the tab out, exposing the sticky side of the protector. I tried to realign it and got that right, but ended up with a fold and bubbles in the protector! That was totally on me for not checking it out though. I'm hoping that the design hasn't changed over time, and that that isn't the cause of people having issues, but I think it's possible that there's a fair bit of human error going on too. TIPS 1. Check all tabs are aligned and that the protector lines up before removing the protection tab from the screen protector. 2. DON'T try and smooth the protector on to your screen- use the rolling tab/lever provided, preferably while removing the protection tab, so it can't stick in advance of the roller (if you evey put sticky backed plastic on your school books, you'll know what I mean!) 3. Leave it in place for a minute after. 4. Use a soft but lint free cloth to push down the edges if needed. Anyway, off to buy another one now..

The screen protector wasn’t made of glass and the quality was disappointing. I tried to install it, but it didn’t look good. I didn’t think it was worth keeping on the screen, so it ended up being just a failed attempt — I threw it all away.

Une mise en place rapide, facile et parfaite. L'écran est résistant. J'ai la maladresse de mettre mon téléphone dans la même poche que mes clés c'est pour ça que l'ancien écran de protection (qui n'était pas de cette marque c'était cassé) maintenant c'est beaucoup plus résistant et malgré qu'il y a un léger décollement sur le côté droit qui apparaît de temps en temps, les poussières ne passent pas en dessous et il reste clean.

Alignment tool works great. Privacy, sad enough doesn't. Had more way more effect with the cheaper ones

Although the screen protector is not bad, it does not fit an s22 ultra. So this review is a review of the description and not the product. Good product. Does not fit S22 ultra.

First of all, I am very impressed by the results. I followed the video and everything was super easy to understand and follow . This by far has to be the easiest and the fastest installation I’ve done with perfect alignment and no bubbles . I installed this on my S23 Ultra and I gotta say I’m very happy with the quality of the materials it is very smooth and feels very responsive . It almost feels like glass. My fingerprint works perfectly well, and my s pen works perfectly well. I did rescan my fingerprints just so that I have no issues and I don’t it works flawless. I highly recommend this product for anybody that’s looking for something close to glass this product will definitely not disappoint. Take your time with the installation follow the video and you’ll get it right with no issues.