J-B Weld 31314 High Temperature RTV Silicone Gasket Maker and Sealant - Red - 3 oz.

Great for attaching seal on Kamado Joe Barbeque

Great high temperature sealant, if stored properly a tube will last you years (writing this review nearly 2 years after my purchase) and its still good with no seperation. If you properly prepare the surfaces by removing all debris and grease this sealant will work for many different applications and materials - if using it on oil pans it is critical you clean the mating surfaces meticulously and degrease them thouroughly, apply a bead and smear it with a gloved finger or plastic spatula and reapply some where it thins out so you get a good even coverage to avoid it blobbing out and don't forget to retorque the pan with a criss cross pattern to make sure you're evenly spreading the torque so the rtv doesn't thin out where there are machining imperfections on the mating surfaces - if you're failing to get a oil pan seal you have a very distorted pan head which is very common, you might be better off using the proper gasket for the pan with loctite 5923 as a liquid gasket and apply this rtv on any joints using the smear technique. I've used it recently as a make shift gasket to replace a impossible to source gasket for a throttle body in a 2012 kia ceed 1.6 crdi that has a EGR and DPF, it's easy to apply with the tapered cap, it cures within a really reasonable amount of time, it's affordable and it has many applicable uses.

Used as a sealant for a motorcycle paper gasket, for the price it was OK. It did the job but I think they may be alternative products that would have done it cheaper.

Another great product from J-B Weld with great service and value from Amazon as always.

Never had an issue using this if you follow the directions. Even when I don't leave it for enough time, this has helped me fix a few oil leaks. Only once my car's rear main seal leaked after changing it and using this - but I had to remove it after install because I didn't add enough RTV so the re-install might have caused my leak anyway. Either way, I wish I had followed the time guidance for that one! It will stay liquidy(?) for a few minutes at least - no need to panic if you have to apply then install something awkward. I would try again with new stuff after 20 mins if it's important and you haven't managed to seal your job together. Seems to set enough to use after an hour or two but it will not be at full strength. It's very easy to apply once, then you'll have to sort out how you're going to store it without it hardening in the nozzle. SO messy! I don't care, I don't want to remove an oil pan for a second time so I use this.

Pretty good stuff, worked well!

Very good

Never used this stuff before or anything like it. Been rebuilding an engine from scratch for the first time. Surprisingly easy to apply, considering reviews of anything like this said it was hard to apply. Bit like icing a cake a suppose. As for whether it does the job well, smells bad and dries quick, I I’ve nothing else to compare it to but I was happy with the result so far. Let’s hope the engine is sealed as it should be.

So this was a longshot. I have a hair dryer with a diffuser. Every time I use it the diffuser goes flying off. It's hot where it clips on. So I tried a bead of this glue and the diffuser is now permanently glued to the hair dryer and will not come off. It was the PERFECT glue for this application. It would be good for anywhere you need glue that gets hot -- like a stove gasket. Great product.

I had to wait for a while for it to be delivered but I am happy that I did receive the item is described a plus plus I still recommend this seller

Es el mejor producto

Cumple las expectativas

Rien a dire de négatif