BonaMix and Fill 5L

Product description and reviews are very accurate ( use in well ventilated area ). Used to finish parquet flooring with saw dust and covered the area needed with some left over.

Cracks out if joint is any larger than a surface mark

Great product and easy to use

Was so hard to get off the floor when it dried. But, did the job.

Takes more than over night to dry .crumbles out for joints when rubbing down .stains the wood when left wet over night .BUT gives a more natural looks than two pack wood fillers when completed.

Excellent product, really easy to use and great results!

Everything okay.

*photos from before any finishing coating applied - but after sanding with 120*tips from a first time DIY buyer/user- definitely use 100 to 120grit sanding dust from an edge sander, my test patch was with 80 and it was too course.- mix it thin, it thickens pretty quick while applying and can become too thick to use quickly,- Leave for MORE than 24 hours with heating on and fan running (manual says 20min drying) especially if you have any sort of depth to the fill. or else your sander will just spread it around and make a huge mess and turn your sanding sheets smooth within seconds.- Avoid knots, try to sand down the knots so they arent as noticeable, avoid filling if you can.I bought this thinking it was top tier and would leave my floors looking like one there were no gaps at all, and for really thin gaps in some parts it did, but its lasting impact was it created grey lines around the boards, after waiting 24 hours hoping they would darken, it was dry to the touch but the sander ended up spreading loads of it around and adheering to the wood surface rather than filling the gaps making the boards grey in loads of patches. went over again with an 80 to remove most of it , but now have to do the whole floor.3 stars because im sure in other use cases it works great (maybe darker wood? or parquet) asked for a refund and it was accepted