QWinOut A2212 1000KV Brushless Outrunner Motor 13T with 3.5mm Male Banana Bullet for RC DIY Aircraft Multi-Copter Quadcopter Drone (4 Pcs)

This an excellent motor. Well built but runs a little hot. Running it on an EWB160 wing. Safe flying.

I had two of these fail in quick succession when my hexacopter was 25 meters up--I even caught the smoke from the first one on camera, which as neat. Presumably, the second failed because current spiked as the craft tried to stay up with only 5 motors (and I thought the rough flying was due to the light wind, so didn't land immediately). But the craft is spec'd to use a max of 22A per motor, so the first should not have failed. I replaced the remaining ESCs with HGLRC FD50A BLHeli32's , and haven't had that *particular* failure since. I might use the remaining still functional QWinOut ESCs for some low-current applications and those where a motor stoppage doesn't immediately lead to damage, like a car or arm.

the motor performed well. I was shocked that compression mount was able to tighten when i put the prop on. One disadvantage is that one bullet plug fell off. I would buy from them again.

The motor worked fine for two tries and stopped working I don’t know why

First time powered up sounded like shaking a can full of ball bearings. Too hot to touch after 10 seconds. DO NOT BUY from QWinOUT.

Ordered a set of 4 since I already had 2 of these for my hexacopter. When I unpacked them, one was marked 1400kV, not 1000kV like the others! Spun it up to compare with the 1000kV and did find it to be a higher kV. Had I not seen this I could have lost hundreds of dollars of electronics and photo gear on the drone. The motors are made well but someone put the wrong motor in the set and it could end poorly for a drone.

1 out of 6 worked.Glade I bought them from Amazon. Fast delivery so you can get replacement quick

These motors go along great with my Tx8 3D printed drone. First flight was a success, the only problem is me, because I crashed it. Motors still working though, even after a few crashes.

Never have any issues with this motor. Do not overload with a non recommended propeller.

Excellent produit

The included propeller mounting collets are for a propeller with a 5 mm hole.