NSIW960 2-Way Speaker (Each) White

This is an awesome speaker as a whole. It serves as my center channel directly below my 50" Panasonic plasma. The sound quality is very good. Installation was easy if you are technically inclined. This speaker was a bit longer than other LCR speakers I looked at in this price range. I decided to go with it partially for that reason (so it wouldn't look so small under the tv). I hand painted the trim in less than 10" with a brush. The grill took two coats with a home depot handheld sprayer (cartridge type, $10). The paint was diluted with water at least 10 fold. If a whole fills with paint simply blow on it to pop it out. The speaker is visible, but blends right into the wall. Given the inexspensive price and all of this, I couldn't be more pleased.

These speakers are awesome! I'm using three for my center, left, and right channels. The sound quality is very good for in-wall speakers and it makes a big difference if you put insulation in the wall around them. Once these are painted they just blend right in. I did have trouble with the tabs that hold the frame to the wall though. I found that the tabs on the left side (when vertical) and the top (when horizontal) had had trouble rotating into place because of gravity. The trick was to screw those in just a little bit so that they are fixed into position BEFORE putting the speaker in the wall. You can then easily rotate the speaker into place and the tabs on the other side will just fall into place. You may have to do the opposite if you need to remove them. Other than that installation was a breeze and they sound awesome. I would highly recommend these!

I installed these 2 months ago, and am extremely pleased with the sound quality. The highs and mids are very clear and crisp, and work well with a home theatre system that has sub woofers. You will not get enough bass from these to use them alone. Installation was ok, but you have to have some comfort level working with drywall and studs. I had to modify the mounts due to some studs that I had to fit them in between- I had to cut the bottom tabs off and screw into the studs. The plastic tabs that are intended to mount cleanly to drywall work well once you get them properly screwed in, but if something causes the tab to not turn 1/4 when you start to tighten, then you have to back the screw out, and fiddle with it until its going to turn as needed to hold against the drywall. Not sure but what a better mounting system could be engineered, but once in they dont rattle. I give 5 stars for sound quality. These replaced 42" tall Yamaha floor speakers. They don't put out quite as much volume, but in a smaller room thats fine.

Recently upgraded my receiver and wanted to clean up my home theater space so I decided to get rid of my bookshelf speakers and mount something in the wall. Having always been a fan of Yamaha, I took a look at their in-wall line and liked the look of the 760s and 960s. Specs were very similar between their single-woofer models and the duals and I thought that I'd like the look of the duals a bit more; and for slightly more ($20 per speaker) the 960s add 20W of power and have Kevlar woofers, which I am hoping may last a little longer than the coated paper. Have had them for several months now so they've had time to break in, and these are nice, natural-sounding speakers. I listen to music CDs or concert DVDs more than movies and, when in pure stereo mode, these 960s have a very life-like staging. If you have a passive subwoofer or one with relatively low power, you may want to opt for an 8-inch single-woofer model, like the Polk MC85, that will give you a deeper response; if you have a decent sub and need your fronts to concentrate on the mids and highs, the 960s should be quite pleasing. And with handling of 150W, they can fill a decent sized room with no problem. As far as installation, these were a breeze. Supplied is a template - simply trace it and cut out your drywall. Attach your speaker wire to the binding posts, press the speaker into the hole and tighten the 6 screws. And if you're painting them before installation, Yamaha includes a plastic tray that fits snuggly into the groove where the grill fits - just put that in place and spray paint the frames, and do the grills as well. I'd suggest spraying both sides of the grill to make sure you've covered the inside of the holes. I matched them to my wall color and they blend into the decor nicely; if you'd rather paint them black to compliment your flat-screen monitor, I'm sure that would look great as well. In all, the 960s are a solid flush-mount speaker. Good power, nice sound and simple installation. Decent buy at $199 each, but a great buy from Amazon at under $100 each.

Really nice speaker. I have Klispch and Polk speakers too. I have installed all 3 in customers homes. I went with the NSIW960 version because I liked the Kevlar cone. I use it as a center and 2 for fronts in my den 18X32X8. The sound is full and clear. The power handling is accurate. I am powering my speakers with the Pioneer VX 1123K and a Pioneer VX 1124K. I also have Yamaha 6.5 3 way as my rears. You will not find a better speaker for the price. Dollar for dollar these these Yamaha speakers are as good as Martin Logan in this price range. They are better than Polk or Klispch at a lower price. Let me be clear. These are not just entry level low grade speakers. They are of excellent construction and a great crossover.

I love 'em, excellent sound and easy to fit. One side went straight int the sheetrock without problems and the rotating locks do a great job of holding the speaker in place. On the other side of the wall, I had to shoe-horn the speaker in between wall studs and it only just fitted. There wasn't room around the edges of the cut-out to let the rotating locks, erm, rotate, so I solved the problem by screwing some 2 x 1 wood battens to the insides of the studs, set back about 3/8 inch from the back side of the sheetrock. I then cut off the mounting fixtures on the speaker and used the screw holes to fix the speaker to the battens using no. 8 x 2 1/2 inch wood screws. Problem solved.

Works great as my center channel. Be aware that it is wider than typical 2x4 spacing if mounting horizontally. I had to remove a part of a stud and build a header to support this as vertical mounting was not an option.

This is my second TV I install the speakers on. Great sound with tons of mid bass... makes for a nice clean installation. My only gripe is if you want or need to remove the grill after they're installed you could possibly bend the metal grill trying to pry it off. I have a different brand that are magnet attached grills which are nicer look and easier to remove.

Simple installation, great crisp sound. Arrived over protected in retail packaging inside another plain box.