Timber Tuff TMW-56 Lumber Cutting Guide

Bolts slip meaning chain bites into clamp. Drill a hole And mount it on your bar or get something else

I bought this at the same time as I bought a Granberg G778 sawmill as this seemed like it would be a little easier for a few certain types of cuts. I've been milling a number of large beams over the last month or so and feel I can give a decent comparison between the two.First, for cutting beams where you can do a proper lay out and screw a guide board to your work piece, this little attachment has far exceeded my expectations. It holds some pretty reasonable tolerances for as simple as it is (the guide board is usually the cause of any variability).Second, it's much faster to setup than the Granberg sawmill, and leaves the saw usable for other cuts (squaring off an end, removing a piece of a limb, etc). It's also much lighter and simpler (fewer things to come loose or adjust).Third, the Granberg consumes major portions of the chainsaw bar for attachment (i.e a 20" bar will barely have 14" of usable cutting length by the time you get it secured, and that's if you remove the felling dogs). This Timber Tuff mill consumes about 3" of the bar nearest the power head, leaving the rest (including the tip) for cutting. These extra few inches are very noticeable.Fourth, there is only one type of cut that this attachment cannot easily do, and that's planking cuts less than the width of a 2x4. The Granberg excels in that regard, but this little guy wins in all other scenarios. The description (and simple instructions) indicate using a 2x6, though it will also adjust down with the hardware to ride along smaller boards. I haven't tried anything less than a 2x4 for tolerance reasons.Finally, as should be obvious, the Timber Tuff mill costs about 90% less than the Granberg. If you're cutting large timbers, this thing will pay for itself with the first one.

別の移動製材機を持っています。この機種の良いところチェーンソーの角度を変えられるので、地面との距離を調整しながらカットできる点です。逆にそれが災いして、カットするのに腕力が必要となりました。角度も変化させて、それを保持できる機構も追加できると、最高の機種になることでしょう。期待します。

Kommt zwar auch aus der China-Produktion (obwohl USA-Anbieter), ist aber preiswert, praktisch und funktionell.

todo completo y listo para usarse

Super outil pour faire des poutrelle longue comme celle de 20 pied ou de la grande planche, j'ai un moulin jobber 100 et je fais des belle planche mais plus les arbre sont long et gros il sont très pesant donc un autre moyen de moins forcer quand cà plus que 12 pied, j'ai percé la plate pour que les vis ne lousse pas et sa évite de casser la pièce de fonte en serrant les autres fourni avec le kit, important d'avoir une bonne grosse scie et la bonne chaine pour la refente de bois de 10 degré, toutes les bolts était dans la boite avec les instruction de montage, aucun commentaire négatif, outil très bien fait et de bonne qualité, outil à avoir dans dans son kit de bûcheronJ'adore pour la qualité prix et c'à faite le travail que je voulais pour pas cher 3 poutre de pont de 20 pied de long en 7x7Merci je le recommande