100pcs 1K ohm Resistor 1/4w (0.25 Watt) ±1% Tolerance Metal Film Fixed Resistor, Multiple Values of Resistance Optional

These 1/4 watt resistors are just what you need for your electronics projects in model railroading, RC cars, and other small electronic circuit work. The anti-static bags they are packaged in also prevent damage to your crop of resistors as you store them between projects.

I ordered these resistors to convert a President Ronald 10 meter radio to an 11 meter radio. They work as expected. They are packaged very well and easy to remove from the binding. I have 99 resistors left, I guess I have to buy 99 more President Ronald radios :)

I replaced my car's dome light bulb with an LED, and because of the way the door switch works, there was still a little current going to it that would normally not be enough to power an incandescent bulb, but since the LED only takes a fraction of the current to power, it would stay on dimly even when the door was closed and it was supposed to be off. Well, I looked up what to do about it and found someone suggesting to stick in a resistor with the same specifications as this one, and viola, it worked! I have it a bit jury-rigged for now, with the leads off the resistor just wrapped around each bulb-holder prong (it's one of those "festoon" style bulbs). If I get the time I'll solder it in a little more nicely later on. The only problem I have now is that I literally only needed one, and now I have 99 left over because I thought I was only getting a 10 pack but it was 100! Haha

Works great. Great value for the money. Came with so many that I will never have to buy them again.

Took my soldering Iron to work and hooked 2 in series. Took home and unsoldered the ones in my Christmas light and installed the replacement need more resistance built 2 more sets and installed one at a time 3 was a charm lights came back on and still working. Just had to wrap the whole thing in the electrical tape that I purchased here too.

If you compare the leads of these resistors to those of other 1/4 watt units, the leads are about 1/2 the diameter of the resistor leads from other vendors such as Elegoo. When trying to insert these into a breadboard, you have to be careful as they will bend very easily if too much resistance exists in the breadboard pin hole.

I’m using it to bypass my hood latch remote start censor and so far so good.

This worked on my ls swapped 944, the tach in the 944 would not pick up the weak 5 volt signal from the ls pcm...installed this in line with the tach signal wire and the factory tach stated working..

I was hoping for a thicker metal and not so flimsy but they do not work just fine.

Well packaged, fast delivery.