Motorcycle Turn Signal Light Indicator Bracket Clamps, 30-45mm | Motorcycle Modified Fork Indicator Mount Brackets Metal Black Fork Relocation Clamps for Turn Signal Mount Brackets

Looking good on the front of my bike. Working nice with the new signals

This worked well. some people reported having to bend the curved part to get it to fit around a fork, I didn't have to do that too much. It's not super sturdy metal, subject to bending easily, but it gets the job done. Worth the $7-9. Comes with mounting hardware that felt like good quality. Low risk attempt to mount turn signals.

Very subtle vintage look. Easy to install. These are 2 wire so no running light. NOT LED so no need to replace the relay. I've seen them installed with the bolt in the front and it looks horrible. If you have room put the bolt toward the back. Fit on my 41 am forks well.

They worked, kind of. They held the light on, which is the primary job. They looked TERRIBLE and had to force them down on the fork tubes to get everything to hold in place.

These are nice brackets. Easy to mount and sturdy when assembled. In my opinion, the metric screws furnished are not sufficient quality for the high amount of tension they are required to hold when everything is tightened down. To avoid a possible surprise when riding, I replaced them with some 1" X 1/4" stainless screws and self locking nuts from the bolt bin at the hardware center. My Sportster forks are 39MM diameter. Your screw length may be different.

I’m a fan of clean-looking motorcycles, so I used these to mount a couple mini bullet turn signals. They work super well! I’m super pleased with how they turned out. They fit the forks on my 05 Suzuki Boulevard S40 just about perfectly. The only downside I noticed (and it may just be my fork size) is that I had to tighten the nut for my lights before installing the brackets. The bracket comes too close to the nut to allow it to spin. Not a big deal, just took a little forethought.

As shown Quality product

Too small for my shocks, if there was a wider spot it would work

Parfait pour fixer une radio

Went on no problem had no issues with it works like it should