3 Pin LED Strip Connector Kit, Include LED Corner Connector, Unwired Gapless and T Shape Connector,Strip to Strip and Strip to Controller Jumper for 10mm 3Pin WS2811 WS2812 LED Strip

My wife bought an LED light strip install kit for a good price some time ago. When I finally got around to installing it I realized that there wasn't any way to safely turn a corner without bending the strip and potentially breaking circuit. After looking around for a while I found a compatible corner kit that allows me to make 90 degree turns cleanly and safely. Be sure you're cutting your strip at the appropriate point otherwise you'll damage the circuit. You can also use the plastic connectors as simple unions if you want to, just take out the corner strips and you're good to go. There's no adhesive on these units but that's ok because my kit has plenty of it on the strips themselves. I found this kit to be a great value just be sure that strips you're going to use with it are compatible. There are a few different versions out there and these corner kits are specific to one style.

I needed to customize some led strips to fit under cabinets, and these worked exactly as I needed. I didn't find it fiddly or tricky at all. First attempts all succeeded.

Bought my daughter a 32 ft. strip of Nexlus Waterproof LED lights. Upon looking to install them, I found that we were going to need to create a 90 degree angle to go from the floor up to the ceiling, then begin lining the ceiling. Fortunately, I bought this set of connectors that included an Angle Corner connector.The big question for me was...how comfortable was I cutting the 32 ft. strip at only 6 ft. from the power source (end with the pins).I took the plunge and made the cut. Unfortunately for me, I wasn't aware of some of the specifics of using these connectors, so the first hour or so was wasted and, to my dismay, I had only a 6 ft strip of lights that worked.After doing some YouTube research, I went back at it the next day and found that:1. I had to cut the waterproof silicone from the portion of the strip I was using to insert into the connectors.2. You have to insert the exposed copper conductors under the silver teeth of the connector. When I did this, it seems to pop right in, then closing the clamp was easy.Upon doing those two simple things, these worked like a champ. I was also concerned with the b-r-g from my light strip lining up with the r-g-b on the connectors. However, this did not seem to be an issue as the lights work like a champ and I have a nice, clean corner angle.Next - I will look to get the T-Connector to go across the ceiling while angling down to the floor in the corner.

It seems like it would work for some 10mm LED strips, however, the pins were wider than the LED strips copper connection on the 10mm LED strips I had, so I couldn't use them - be careful on banking on these being your solution. I would suggest ordering a few different varieties and try how each one works.

El producto es muy bueno, los conectores son de buena calidad, funcionan muy bien

Super touchy connections. I split the tape into 8 runs for a cabinet; only the first two would light in "warm" mode. Others began to light in higher K ranges. After measuring, assembly, gluing, I'm now stuck with two colors or one bright color I don't like. Wouldn't recommend.

Know before buying that these things DO work but are extremely difficult to work with. Firstly, you'll need magnification to see well. I used a knife to "prime" the prongs so I could get the light strip into the connector. Best advice also is to use pliers and such don't try to manipulate with your fingers, you'll just hurt yourself! Suggest practicing one or two on a scrap first.

Everything I need. Now I need to find a carton of patience somewhere….🫣😵‍💫