MUXSAM 1-Pack Round Golf Screw Wrench Spanner Tool

Worked as advertised, make sure the prong end is fitting tight to your weight ( I held it my fingers and gave it a turn ) it came right off. I could not turn it with the wrench that came with the weight set.

Works well for changing putter weights on Scotty Cameron putters

The tool worked perfectly after placing my putter in boiling water for one minute. Old weights were removed and new ones installed and tightened.

Great alternative to the SC tool. Definitely need a 3/8 ratchet to loosen the factory weights. The prongs fit perfectly into the factory weights. Be careful if it slips, one prong slightly bent. It didn’t bend enough to make it useless, but it bent. I also had to use a 1/4 impact driver with a 3/8 socket adapter for one of the factory weights. It was really in there. A couple blips with this tool and it was loose! After market weights prong holes are not as deep. The tool did not bottom out, but as long as you only hand tighten, it’s fine. Not sure if it would remove aftermarket weights if they are secured with loctite.

The tool for the most part is what it says and arrived on time. I will say it does not lock onto a 3/8 inch socket. It will still work but you have to be mindful it can come detached. My weights were really tight in my putter and this worked perfectly to get them out so overall happy.

Worked great!

This thing sucks. Socket isn’t made to the correct tolerance so it just falls off if you don’t keep a finger on it. Which defeats the purpose of this tool and prevents you from using the leverage of the ratchet. Cheaply made and overpriced.

Tool worked very well

Good quality work well with all my Scottys

Great item. I bought it because it was the cheapest one but it turns out its the best one. You can fit a 3/8 ratchet or bar. All those people that bent the prongs just didnt use it properly. You would buy the 50$ scotty cameron one and get the same result. I had a 2010 Squareback 1 with with old generation weights that had never been removed. You need to heat the putter (I left it in hot water for 10-15 mins) I dont recommend a torch because those weights have rubber gaskets in them. Press the tool firmly on the putter while unscrewing, otherwise the prongs will slip and bend or scratch your putter. Its the design thats flawed, not the tool.

シャフトを短くしたのでバランス維持の為、ウェイトを交換する際に使いました。1インチ当たり5g✖️２個分増加させます。好みもあるでしょうから、あくまで自分の場合です。 取り外す時は緩んでレンチを使う必要のない時、締める時は行けるところまで手で回せるので、これツールは使い易いです。レンチで力を加えても問題ありません。勿論、人力の範囲ですが。純正品ではありませんが、実用には問題ありません。 2インチカットで、バランスも良く、マイパター感が最高です。

スコッティキャメロンのウエイトは交換が難ししと工房で言われたがこれがあれば簡単にとれました。

It’s a wrench for Scotty Cameron putters and it works. What more is there to say.