LISEN Magnetic Phone Holder for Car, Car Phone Holder Magnetic with Upgraded Clip & Ultra 6 Strong Magnets, Magnetic Car Phone Mount Magnet for Car Automobile Cradles, Soporte de Telefono para carro

Excellent product. The magnet is very strong and holds the phone securely even on rough roads. Installation was quick and easy! Simple, sturdy, and very reliable. Highly recommended.

I’ve been using this magnetic phone holder in my car and it has been very convenient for everyday driving. It holds my phone securely even on bumpy roads and makes it easy to use GPS hands-free without distractions. Installation was quick and straightforward, and the magnet strength is strong enough that I don’t worry about my phone slipping or falling.

I highly recommend this phone holder! I drive for work and get my phone in and out a lot at stops, so this is a better alternative to the traditional holder that you have to click/unclick to hold the phone in place or release. I also don't have to worry if my phone fits. I can swivel the phone at many angles...for the map, watching movies, etc. The magnets are super strong so the phone doesn't fall off if you hit bumps or anything, but not so strong that it is hard to get the phone off. I do recommend holding the part that is clipped on the vent and putting your phone on and pulling it off a few times when you first get it, to weaken the magnets just a little so it doesn't put so much pressure on the vent and isn't too hard to pull off with one hand. I have used mine almost every day for over 5 months and it still has a strong hold. I have ordered 4 more for other people that liked mine and 3 more for myself for "backup" in case I can't get them when I need them. I am curious, though, as to why the picture shows 2 of the round magnets, because the box only contains one. That's the one I prefer because it is smaller. I was concerned that the magnet being on my phone case would snag when putting in in my back pocket, but nope! It slides in with ease. Very happy with this product!

I bought this because the previous cellphone holder that I had partially blocked the charging port on my phone. My phone is kind of old and I have to stay on top of the battery to make it through the day, so charging it on my way to/from work or on long trips is essential. This mounts by hooking onto one of the slats in the dashboard vent. The hook is then retracted until it captures the slat tightly. This is not a problem with vents that have slats of the same depth, but the vent on my dashboard is curved. This tends to skew the holder upward as it is tightened. I had to try a few times until I could get it to hold securely and not slip out of position. This puts a lot of pressure on a single vent slat, and we'll see if the holder and/or the slat decide to break over time. The magnetic mount is nice because it leaves the entire perimeter of the phone unblocked, but you need to have a case with steel in it for the magnet to attract. My phone case doesn't so I had to bond one of the included steel plates to the back of it. I initially tried to slip the steel plate between the phone and case (something the instructions tell you NOT to do, to be fair) but the distance between the magnet and plate is too large to keep the phone in place. My case doesn't have a flat back, and I was afraid that the self-adhesive steel plate would not bond well so I used 3M high-bond double sided tape to adhere the plate to the outside of my phone case. This is VERY secure-- I'm pretty sure I'd bend the plate before it ripped off the back of the case-- but it makes the plate stick up from the back of the case by 1/8". As a result it snags on other stuff in my pocket and it has a hard time fitting in the phone holder on my motorcycle. Note that this is not the fault of the holder AT ALL-- it's merely an experiment on my part that didn't work. In the future I'll probably switch to a magnetic case for my phone, IE one that has a steel stand on the back. That will be a cleaner solution than the hodge-podge that I have on there now. Keep that in mind if you have a phone case where it will be difficult to adhere a steel plate. I used the holder for the first time this morning. I can tell you that the magnet GRABS ON FOR DEAR LIFE. I stuck my phone onto it and drove to work, and my phone didn't budge a bit. I'm really impressed with the strength of the magnet. So far I like this holder, and I'll like it even more when I get a new phone case. I'm a little leery of how it clips onto the vent, and time will tell how durable that installation is. For the moment however, this holder is working very well and holds my phone quite securely.

Works very well. Clips firmly onto the vent and the magnet is really strong. My phone doesn't move when it's mounted and has never fallen off, even on a bumpy road. It keeps the phone just as stable as the non-magnetic type, but this is much easier to use with one hand. Highly recommended.

I've tried several different styles of holders over the years. These are the 1st ones that actually do the job 100%, not halfway or just ok. These are great. Used in Volvo S80 & Toyota Camry - fits perfectly in both.

Had purchased one previously and needed a replacement for a different brand. Found it was still available and still a good price, so it was an easy decision to get another one. Again, it works as designed and seems to hold the phone firmly. If this is your first time with this style holder as with all vent mount holders it will restrict the movement and adjustability of the vent you mount it to.

Great when it doesn’t break. I’ve bought 3-4 of these now. The work fantastic but only last about a year. Good thing they are cheap

افضل حامل جوال على الإطلاق أنصح بشراه

Cheap but great value, love how it grips the vent vane like a Jack Russell with a squeaky toy lol. Best mount I've ever had, so convenient. Some one-star reviews complain the magnet is weak. I have a heavy phone and the magnet is super strong. The only downside is very weak plastic and the hook snapped. Super glue fixed it, but I need to be careful pulling phone away as it might snap again

Had this for a couple years now. Works great, phone sticks wonderfully. Easy to install and take off when needed. Comes with two magnets, a circle and rectangle. If you have a very large heavy phone I recommend trying to use both inside your case. I don’t stick them to my phone. I just pop them in the back of my case which is great if you change your phone as you’ll have them forever. I only need one magnet for my iPhone 13.

Good quality

Amazing product