Food Grade NSF FDA RTV Silicone Sealant Adhesive Clear 10.3oz (1) (10.3 Ounce Tube)

used to make ollas. sealed clay 2 pots together and also to close clay pot drainage holes. You will need caulking tool for this product

My MB MES130 smokers are lucky to last 5 years. The failures are due to moisture intrusion, originating both inside & out, resulting in a failed power supply, digital control panel, and/or heating element. The smoker is covered with a MB outdoor cover when not in use. This sealant is rated for 500F and FDA approved for food contact. I have applied this sealant to all internal panel joints, exterior access panels, and other penetrations. This should minimize moisture damage, and for a $12 caulk tube MasterBuilt should be doing this on their own.

I successfully repaired our leaky dishwasher with this adhesive. The leak originated from a broken seal in the rear of the case. After more than 30 high temperature cycles, the leak repair is still good. It seems to be durable. FYI, after sealing, I let it cure for a few days, due to the fact that the environment is the inside of a hot dishwasher. Ancillary advice to dishwasher owners: DON'T SLAM THE RACKS IN AFTER LOADING! If you let the heavy rack bang or press into the back of the dishwasher when you close it, the impact can break the seal along one of the seams in the back. Then you will need this adhesive. :-)

yeah it is food grade silicone, is what it is called

It seals and is durable. Very easy to use.

Worked great. I did take about 48 hours for the odor to dissipate.

Great product for chickens water bowl

Building a camper van and needed adhesive with tackiness for all surfaces from low to high temps. Normally 3M contact cement is used for installation of underfelt carpet and insulation, but I'm no pro, and contact cement is one chance to get it right. So took a chance on this silicone based adhesive as I figured it may give me more time to get pieces lined up correctly. Did experiment using piece of scrap panel underlayment and aluminum insulation foam. Spread silicon adhesive with drywall joint knife to a uniform later, placed carpet on top, it stuck without pressing, removed to adjust, then reinstalled, pulled carpet tight on edges, roll pressed carpet into silicone, and let dry for two days. After cure the carpet won't come off any surface without around effort. Scaled up to full panels worked great, easy, and gives enough for adjustments during install. Used about 1 tube of silicone for each 3ftx3ft panel. Even works using sparingly zig zag pattern to stick Thinsulate insulation to walls for sag prevention. Will be using in future for speaker box too.