ADE Red Dot Mounting Plate Compatible with Springfield XD XD(M) XDS Non-OSP Models – Dual Footprint Fits Docter/Noblex & RMSc Red Dot Sights - Works with Osight SE, Vortex Venom Enclosed, Holosun 407K

My husband loves this. The quality is great. It was easy to mount and fits perfect.

Absolute trash. This was actually the second one I got because the first adapter stripped out with barely any torque while mounting it. Amazon replaced it, so I figured maybe I just got a bad one the first time. Nope. I mounted the replacement using an inch-pound torque driver and tightened everything to spec, so this wasn’t from over-tightening or installing it wrong. Everything felt snug and good to go. Took it to the range to sight in my optic, and after maybe 15 rounds the screws ripped right out of the plate and my optic came flying back into my face. Ended up with a knot on my forehead and blood running down my face. That’s beyond unacceptable — it’s straight up dangerous. An optic plate should not fail like this, especially not after being installed correctly and barely used. Between the first one stripping out and the second one launching my optic into my forehead, I wouldn’t trust this thing on a toy, let alone a firearm. Do yourself a favor and buy literally anything else.

Fits my XDS-9, wish there were more options for other types of red dots. But this will do.

i used this to mount a red dot sight on my springfield armory xds .45. its a little wider than my slide but that is because an xds is the slim model,which is why its narrower. works perfectly so far.

Precision fit and rock-solid performance. Great budget option for customizing optics setup.

Great product! As described!

After installing the mount and optic using the manufacturer-recommended torque of 12 inch-pounds, I experienced an accident in which the optic and mounting base detached from the pistol during use and struck me in the face. Fortunately, I was wearing safety glasses, which prevented any injury. Initially, I assumed this incident may have been due to an installation error on my part. However, as a result of the incident, one mounting screw and a metal alignment pin from the slide support were lost, requiring me to purchase a second mounting base. I reinstalled the new base, once again carefully ensuring the correct torque specification was applied. Unfortunately, the same failure occurred again under identical conditions. Following this second incident, I conducted a detailed inspection and determined the root cause of the failure. The screws provided to secure the mounting base to the slide are not of adequate length. Specifically: * The mounting base thickness is 3.5 mm * The slide receiver depth is 1.8 mm * The total screw length is 4.7 mm This configuration results in only 1.2 mm of effective thread engagement, leaving approximately 0.6 mm of thread missing for proper fastening. In practical terms, only about **66% of the thread is engaged**, which is insufficient for a secure and safe mounting under recoil. From my perspective, this represents a clear design flaw that poses a safety risk to the end user.

best if use sight vise to install