HD Switch - Made in USA - Ignition Key Switch Wiring Harness 18" - Garden Lawn - Standard 5 pin for Toro Exmark Hustler John Deere M90206 Cub Cadet Troy-Bilt Ariens Gravely Simplicity Snapper Murray

Product came well packaged, wires and connector was of good quality, the 18" wires worked perfect for my Troybilt tiller. USA made is a plus.

nice tight fit

Put this on an old Briggs motor electric start works great three wire switch three position. Switch on off crank works great good quality.

Replaced my melted ignition switch connector on a Craftsman GT6000 tractor ( I repinned all the wires from the factory harness and just replaced the 1 wire that melted the connector)

Worked well and price was good

Super nice and heavy duty wire

It was great to be able to put the colored wires where I wanted them. The problem is these spade connectors have a small raised dot. It latches the connector onto the tab of my ignition switch - and then cannot be removed. I discovered this before assembling the full connector block. The solution was to use needle nose pliers to flatten the raised dot. Now the connector block can be disconnected when needed instead of being permanently connected to my ignition switch.

This makes it easier to connect an ignition switch.