TotalBoat TotalProtect Epoxy Barrier Coat System (Gray, Quart)

Used it as a primer coat for Interlux BilgeKote in the bilge of a boat while engine and outdrive was removed for rebuilding. All application surfaces were cleaned and degreased. The surfaces over which this was applied was a mix of epoxy, JB Weld, and gel coat. Areas were painted with a 4" foam roller and a 2" disposable brush. The foam roller purchased from the local home-doodle store started to crack and get limp right around the time I finished (1/2 hour later) apparently due to the chemicals in the primer attacking the foam. Primer adhered quite well to all surfaces, even the smooth areas of the gel coat which was not scuffed. This stuff just plain sticks! One quart was ample with about 6 ounces to spare for any touch-up. Epoxy mixed well with drill and mixing tool. Clean up with Xylene was painless.I have yet to apply the BilgeKote, but looking at the instructions, I expect no issues.

Works as it should and easy to use.

I own a 12' fiberglass boat. One quart ,thinned out properly using Thinner 200, was able to coat the entire inside of the boat twice. So I was able to achieve the recommended coats of 4-5 by using two quarts. I applied with a 9 inch roller with a 3/16" nap. (I didn't tip and roll) All supplies were made by Wooster. Be sure to follow instructions carefully.One side note is to buy a mixer attachment for a drill. The base (paint) is very thick and needs to be mixed thoroughly before mixing with the hardener. Stir for 2 min. Induce 15min ,thin and apply. I have 0 complaints, and will buy again for the next time I need to paint my boat. It's important your roller nap is 3/16" for this two part Primer. Mix the proper amounts and it should go smooth like my experience. Good luck folks. Don't cut corners and get yourself some Wooster supplies .

Good product. JDT is good stuff

Great product I recommend throughly mixing the paint before adding hardener and it’s 3 to 1 ration you will be fine.

I used this paint on a marine-plywood rowing boat. As an epoxy, it bonds well with wood and with scuffed coast of epoxy. This is my below-the-waterline barrier coat and I'm also using it on the interior planks of the dinghy as a waterproof primer.This paint is the consistency of mayonnaise with not much liquid in the container. You'll want an electric drill-powered paint mixer to thoroughly mix the paint and the catalyst. It rolls on thick and easy and doesn't sag but the finish is not smooth like topside paint. Use as-is to protect fiberglass boat hulls. I'll leave it as-is below the waterline but am using two coats so I can sand it smooth and fill with a primer above the waterline before applying topside paint.Also, the directions say to let the paint sit after mixing. Pot life is long so no need to hurry like you would with 5:1 epoxy.

We used this epoxy to paint and line my stock tank pool. The pool had started to rust over time from the chlorine in the water. This is a great solution. It looks great and it’s wearing well so far. Easy application, and short cure time.

Quality epoxy paint, which has gotten hard to find at brick and mortar stores. I used it to add protection to a new propane tank located in a marine environment. I also purchased the same brand's thinner