Rear Window Louvers

Easy to install I’ll tell you the way I did it. Lay the glossy or top side downAttach the eight metal fasteners to the louver tape side up facing you put the retaining nut that holds the metal bracket in place make sure you have overhang of bracket toward the inside tighten it down Pull the red plastic out of the two sided tape Open little tube of glue and spread some across each of the two sided tape pads spread it good pick up louver easier with two people and place on glass making sure it is Aligned evenly around

I wish that I could give this product negative Stars. Useless piece of plastic do not waste your money at this point I am trying to get a return the product they sent me was warped effusion pieces won't hold down the product so badly warped

What I've found to work best is if you take the brackets it comes with and razor blade the original adhesive off because it's awful and doesn't stick and replace it with double sided Gorilla Tape. Also the brackets come with cheap plastic acorn nuts so I replaced them with steel m5 acorn nuts to fasten to bracket more securely...all in all it doesn't line up perfect but you can make it look decent and for what we pay for it it isn't that awful for an ABS plastic...and looks dope once you get it the way you want it...I HIGHLY SUGGEST USING MY TECHNIQUE FOR BEST RESULTS...

It looks good. Especially from afar. The cuts aren't straight on the side edges. The top corners don't have mounts supporting them and they stick up probably catching air so I taped them down. Mounts don't contour with the back glass, neither do the louvers properly. There is some gaps. I'm happy with the general look but not pleased at the manufacturing quality. Their are 2 mounts on each side. The tape doesn't stick perfectly as it should to secure it. I had to dab glue on half of them. I also removed the foam tape on the roof side at the top because the gap was so large but I couldn't tighten the nuts all the way down because they are nylon acorn nuts that strip out. I'm also pretty sure they are standard and the studs are metric. The studs are metal so I'm going to see if metal nuts will work to lessen the gap as to be better aerodynamic and not fly off. Id recommend not using loctite as it will probably eat the plastic making them brittle. A touch of super glue might do but the tape is already gonna be frustrating removing and replacing every time I need to clean the back glass. Looks good but a pain in the butt. You have been warned. Manufacturing coulda done better here.

Great look for my car. Gives my car a different show up look entirely. Love how easy it was to assemble to my car.

The product was fine… (no directions came with for assembly I had to look on Amazon for seller directions) it does have fabricated hardware that is inconsistent size pieces. I attached the product to my vehicle and it looked awesome, however in the directions state “silicone around product” after I did this process it looked like crap! Caulk was all over product and all over my vehicle.. I’m pretty disappointed now I have to bring my car in to get professionally cleaned.

the louvers fit perfect BUT... No instructions ,came with two tubes of something with Chinese writing all over it with "adhesion promoter" on it where the hell am I supposed to put this stuff. I still have not installed this thing.

Adhesive did not work would not stick to the window