Plastic Extension Tips for Mercury CA Bottles

I build my own Crossbow Bolts, Golt Tip Nitros. I have a spine index jig so I can correctly fletch my bolts (after building they weigh 608 grains) when attaching my Bohing Co Vanes, I use Mercury CA for adhesive, these small tips are perfect for applying the correct amount of CA glue, the clean up w/ acetone (as does all my felching jig parts) If anyone has a problem w/ applying too much Mercury CA on a project- these tips are the best solution

They are better than nothing. One the one ounce bottles they seem to be a little long. I hove used another CA's mfg tips that are either polyethylene or Teflon that I can stretch over the end of the bottle tip. These are drawn out to a small capillary tip.

I previously used tips from the hobby shop and these are much better. Holding the CA bottle vertically and blowing out the tip lets you use it multiple times without replacing. The hobby shop ones would plug after 2 or 3 uses.

Mercury has the best bottle design in my opinion. Stays cleaner than every other ca bottle that I’ve tried.

These application tips are a definite improvement over using the glue directly from the bottle. However, I use this glue in fine detail work and a finer tip would be helpful.

Precise control the amount of CA

These really work well. They drain completely, and you can clean them by submerging them in acetone.

Just as described