EF2200-QA

Replaced an older pump that was still working on an Irontron 8 gallon ATV sprayer. The older pump had lost some pressure and this one works great. Total replacement time might be 10 minutes. Unit is very quiet. When I use this unit I usually spray fire ant killer, 2-4-d, or Roundup. Clean the unit after each use!!!!I get amused by people who rate a pump as not lasting very long but works good when it did. I have to believe that many users do not clean the tank/pump after each application. I learned the hard way, but now I do not have any issues with pumps. There is not a pump sold that will withstand harsh herbicide/pesticide chemical on the interior seals. If you clean the tank/pump after each use it will last a long time. Here is what I do:1. Drain the tank of any remaining fluid2. Add water to the tank and then drain it again3. Add about 2 inches of water to the tank, power up the pump, and spray the water out4. When the water hitting the ground loses the suds or soapy appearance the unit is now spraying mostly water.5. Unpower the pump and squeeze the lever on the wand to remove the pressure inside the pump.6. Store the unit for the next use. I always leave some water in the tank, but not in the pump.Good luck. It only takes less than 5 minutes to clean.

Bought a sprayer from Northern Tool to replace same one that I had used for many years. Didn’t think to check warranty on newer one before buying. It lasted 3 1/2 months and I found out it was only guaranteed for 3 months. Ordered this one and it works great. Much cheaper than a replacement from NT, and much better pump!

The OEM motor rusted up -- it seems that this piece of outdoor equipment is not even water resistant!Anyway, I needed to replace the motor and this one works perfectly. It was easy to install, as it used the same mounting bolt pattern as the original.So far, works great, but I am keeping a tarp over the sprayer, now.

I bought this pump for building my own Softwash system.It works perfectly, only we have to try it out in practice to see how it preforms.We living in the Netherlands the only issue we have to find the right connectors to connect this pump to garden hose.

The media could not be loaded. I been using the same model pump since 2021 for softwashing and they usually last anywhere from 6-8months but the pass 3 I’ve had only held up for few days of few weeks. They all almost immediately start leaking from the diaphragm and all ways end up leaking inside the motor housing…. What is going on with everflow ? Quality has dropped that bad ? They used to work for minimum of 6 months with not leaks on the pump. Usually the motor would get tired and just not put as much gpm so i would swap for a new one but now the pump seals are just not holding up. And I have to wait almost 1 month to receive a replacement? I’m currently looking for another brand! I all ways kept a spare pump in my trailer the only problem is I rant out of spare pumps and still everflow has not even shipped the pump I ordered 2 weeks ago.

First pump was delivered with issues second pump was here the next day fantastic customer service I was able to get to the job site the following day pump work fantastic met above expectations would recommend

Kinda unorthodox packaging but I’m not planning on babying the pump. Was a bit damp on arrival.Pump didn’t work at first but it turns out a fuse blew in my wire harnesses,(not the pump fuse) was only a 7.5amp fuse. Threw in the correct size and it’s been running well.Iv had 4-5 of these and they normally last me the better part of a year running caustic chemicals through it. I rinse with about 5 gal H2O after each use.

Have used it probably a dozen times now over the last month and keeps working.. even if I was to get only one season out of it, it’s Worth it compared to the higher prices Of others, hope it keeps working for the next seasons to come