HQMaster 1/8" Shank Compression CNC Router Bits Spiral Up & Down Cut 5 Pack | Tungsten Carbide CNC Bit with Nano Blue Coating, Spiral End Mill for Plywood Hardwood Laminate, Clean Edges Both Sides

I've been using the HQMaster Up & Down Cut Compression Bits (1/8" Shank) on my 24x48 CNC to cut hardwoods like walnut and maple, and they've performed exceptionally well. The longevity is impressive, especially considering the price. Like any bit, they can break on knots, but I’ve found this usually happens when my speed and RPM settings aren't properly adjusted, not due to the bit itself. When dialed in correctly, these bits cut cleanly and hold up just as well—if not better—than some better-known brands I've tried. For anyone working with hardwood, these are a solid 5-star choice. Highly recommended!

Worked well and seem to hold up fine.

My first set of bits Brittle and weak

Very good set of bit and at a great price. They worked very well in my CNC router and produced the results that I was wanting.

What's not to like? Economically priced and they work great. This 5-pack costs less than one single bit from other brands and they cust just as cleanly.

Using these bit in my cnc router. Good cutting speed. Nice cutting edges with little tear out. Good shipping.

Good quality for the price, cut very clean and keeps that cut quality for at least ten batches of 32” by 32” sheets of material

All good

Just ordered another 10 1500mm min 1.5 deep in hardwood, and Australian Spotted gum too!