Key Fob Keyless Entry Remote Shell Case & Pad fits Chevy Colorado Venture / GMC Canyon / Hummer H3 / Pontiac Montana / Oldsmobile Silhouette / Isuzu

My OEM fob for my 08 GMC Canyon had seen better days. The internal circuit board was still good, I just needed a replacement cover and this cover fit the bill for the best value. The fob cover is completely compatible, with the push buttons aligning on the circuit board flawlessly. There is one tricky fitment to replacing this fob, and that is getting the circuit board to fit inside the rubber frame of the push-buttons. If crafts and intricate detail workings of fitting small parts together is not your strong point, you had better let a professional install it for you. Otherwise, with patience, and small micro-tools, I was able to fit the board into the rubber button frame with ease.(at least, for me). The fob comes with 2 extra battery contact stems, which are another micro-fitment procedure if you have the talent for small crafts. Once assembled, the fob looks good as new! The buttons work flawless and I'm set for more exciting years of driving fun with my new fob case.

It was a great transition. My original fob was broken. I had to keep it in a separate pocket from my keys. The shell perfect replica. I simply took the innards from the broken fob to the new shell. It works great and its now attached to my key ring.

Didn't work for me. Doesn't come with the battery clip/contact, and the molding for the clip is not precise. Took me about 20 minutes of finangling and swearing under my breath to get it installed, and then another 20 minutes of troubleshooting to try and get it to function. It's either a low-quality 3D printed copy of the original, or poor QC in the manufacturing process, but my guess is the battery contact is not making a good connection to the circuit board. Don't waste your money. Just buy a new fob from Ace Hardware.

Fits great , easy to install compatibility with my H 3 oem controller

I got this case because the ring hole snapped off my old one, so I had to carry it in my pocket and couldn't attach it to my keys. The case worked, looked nice, and had all the necessary parts. But the internal shell was too small, I spent a a few minutes trying to get the old circuit board in by force but was afraid I was going to snap it in half trying. And I tried a few different ways to get it in, from trying it with the rubber button pad inside, then trying to put it in the pad, and then the pad into the case, but it still was just barely too small. I ended up using my knife to shave a bit of the internal plastic off the wall to make it fit; regardless, it was still very tight. The other problem was with the back part, the little metal where the battery touches were not properly attached, and after further inspection, that's because the slits for the arms were not cut out, again, I used my knife to cut them, so it would fit. Unfortunately, the metal piece that came with the fob had the prongs too tight, so I tossed it and used the one from my old case. Overall, it works fine but be prepared to use your old parts, and don't be afraid to use a little force with it.

Not easy to put together and I had to trim the original circuit board to fit this unit.

ARRIVED EARLY AND ITS A GREAT FIT.DURABILITY IS EXCELLENT.AND FUNCTIONS SAME AS THE ORIGINAL.AND VERY SATISFIED WITH IT.

This is a good item although it is not listed as such it is semi universal. Watch very closely when you take the board out of your old fub. The battery contact tin may have to be bent in a reversed position for it to work.

Worked well and was easy to change over

Excelente

Excellence replacement. Recommend.

Por el costo bueno

No me gustó que de los dos controles que compre, solo uno funcionaba los botones del control.