ARCCAPTAIN Plasma Cutter, [Large LED Display] 50Amps Cutter Machine with 110/220V Dual Voltage DC Inverter IGBT 1/2 Inch Clean Cut Post Flow and 2T/4T, for Beginners DIY

This is a great portable machine for light gauge cutting. It will cut heavy items but seems to struggle. It is perfect for HVAC spiral duct and cutting sheetmetal. It works well on auto body as well.

Been using the cutter for a few months. My only complaint is that since it's a "drag" type cutter it goes through the consumables pretty fast. The bright side is that the replacements for the cutter are not expensive and very easy to get. The air pressure regulator is a little touchy but works as required. I have a small shop compressor so I have stop cutting when I hear it kick on. I've only used this on 250VAC 50 amp supply so i can't comment on the 125VAC operation. I've cut everything from 18 gauge sheet steel to 3/8" steel plate. Not exactly industrial strength but it works great for my hobbies and repairs. Controls are simple and easy to use.

Awesome cutting machine. It's so simple to use and makes greats cuts on 1/4" & 1/2" steel. Just follow the recommended settings for amperage and air pressure that are on the website. What little slag was there chipped right off with a slag hammer. Should have bought this sooner.

Purchased for my husband. He loves it. Works beautiful! No complaints!

Good value for home shop

Arrived quickly Easy setup. Played with a little bit, pretty impressed so far. Cut through 1/2 inch steel quick and clean. Not great for ling time use, 2 to 3 minutes, then let cool for a couple of minutes

cut smooth works great

This is my first plasma cutter purchase. I am restoring an old John Deere riding mower and needed to fabricate a mount for new motor, etc. After watching several videos and reviews I decided to go with this one. In my limited experience it’s a good one. It’s easy to set up and operate. The controls are simple. It comes ready to use right out of the box. I did make one change before even turning it on though. It comes set up with a hard line air fitting instead of a standard quick connect for an air compressor hose. So I changed that so I didn’t have to fool with putting a fitting on the hose it comes with. It took a few practice cuts to dial in the settings and for me to get used to using it. But it does a great job.

Das Teil Verdient 10 Sterne es schneidet problemlos auch dickes material ohne probleme der schnitt ist so sauber das man nichts nacharbeiten muss es ist wirklich ein hammer Plasmaschneider ich habe es schon sehr lange und noch immer die erste Düse drinen ein wirklich geiles teil einfach perfekt

Es una tomadura de pelo.

Fa bene il suo

Au premier essai il est super je recommande

Aunque corta grueso, el acabado no es el mejor. Aunque por el precio no está mal.