Garage Door Seal Top and Sides, 34FT TPE Garage Door Seal with Adhesive-Backed, Weatherproofing Garage Door Seals with Nails and Lids in White

This was surprisingly easy to install due to the adhesive strip that holds it into place while you put the screws in place. Took us about 30 minutes to install. I like that it comes with the caps for the screws, which give it a clean and finished appearance. It seals the gaps around the garage door well and looks like it will help keep dirt, bugs, and heat out. Couldn't be happier.

The adhesive on the back was very useful to hold it in place while running the screws through the edge to keep it on. I like that it came with snap on caps to cover the screws with. Nice clean look when finished. Now my garage door won't be drafty in the winter. This is the first time I ever installed a garage door seal and I'm glad I finally did it. If you are thinking about sealing your garage door then look not further. This product is the real deal. And very easy to install.

Good so far for the price.Be cautious while installing, I measured mine to the exact length. The two side pieces installed easily but while installing the top piece it stretched by about two and a half inches. I ended up mistrimming it so it's not as good an installation as I hoped for.Be careful using a drill driver to drive the screws. It can easily over tighten the screw and pull it through the hole in the screw cap making the screw cap unusable. If properly installed, the screw caps are still difficult to snap closed.The seal on the closed door is excellent immediately after installation. Only time will tell if this stays true with exposure to sun and weather changes.Update: 5 caps popped off over 5 days of use.

It's an awesome product! After searching on-line for something to cover the small gap at the bottom of my garage door, I decided on this product, and so far it's perfect. Excellent quality rubber seal - sturdy - it comes with quality screws and even screw covers. There's a rubber seal on the bottom of my door but it's a little old and would be difficult to remove - this new seal reinforces the gaps that were forming.

This is a good product. As others have said, be careful and take your time. I waited for a warmish day, 55°. The included screws are 1” #6 flat countersunk. They can squeeze through the hole you drilled and do not grip the material very well. I bought a pack of 3/4” #6 truss head screws (my local stores had none). They act like a small washer and hold without tearing. I set them every 6” and there are no visible waves anywhere. Very happy with the result and as evening came, temps dropped and wind rose. It looks good and works well.

It’s easy to install but those white clips are very loose .

Easy to install but the directions could give a little more detail on how tight you need to put it to the door.

I just bought a new home and there wasn't any weather stripping on the garage door. Though this was my first time installing weather stripping. It only took me a couple of hours. The hardest part was the top since I was fighting gravity. The sticky section isn't really sticky enough. It would have been so much better if the sticky had made the strip stay in place even for a few minutes. I was trying to hold it in place and drill the screws in at the same time. While on a ladder. Got a bit awkward at times. Both sides of the garage door were easy. It's easy to cut to needed length. The little white screw head caps are very fragile. I think I broke every other one. I ended up just getting some white paint and painting the heads of the visible screws. My garage door and the trim are white so the weather stripping blends right in. Looks nice. It seems to be helping control the temperature in the garage and keep some of the bugs out.